Separate names with a comma.
Not as much evidence of corrosion on the pan. Lots more corrosion on the bussbars, and you can see growth of corrosion coming up through the...
Yeah, that's why I switched mid paragraph from talking about o-rings to plastic gaskets. The gasket can be made to the exact profile of the...
Unless these last two modules come up worse off than the best of the modules from the other pack, I will be discarding the whole "documented"...
From Module 24, three cycles: Cycle | Discharge | Charge 1 | 1439 | 2543 2 | 2584 | 3062 3 | 2942 | 3917 This is better than the best of the...
Module 38: discharge 2062 charge 4018
Great! thanks! Ok I got the results from the first charge cycle on module 19 (from block 10, which I judged as a representative of the worst...
Looks like I may need a set of voltage sense leads. I noticed that one broke in taking them off this battery, and went and looked at the leads...
Module voltages in attachment. Particularly bothered by modules 24 and 25. There's much more evidence of leakage in this battery, not too...
OK, the old battery has been tested as much as I can think of. The buss bars and holders are clean. The modules have been washed in vinegar,...
Ok, I didn't force charge it, I simply looked for a place to park immediately after the long downhill on my commute home from work, where I...
While I'm at it, I had noted a statement that if MG1> MG2 this is an indication of a failing transaxle. I was sitting in the car at lunch,...
Sorry my question referenced battery temp, but what I was asking was whether force charging is potentially more damaging to the TRANSAXLE than...
Is force charging any worse than just regenerative braking? I can certainly see the battery temp rise there, but I haven't been monitoring...
Bob, I get that the green line is amps drawn on or charging the battery. What is the volt measurement, and what is the scale? Also, what are...
I should be able to monitor transaxle temperatures with the scangauge. What are reasonable temperatures to expect? And what would be cut off...
How does one "force charge" the battery?
Also, if you want any of the bad modules, you're welcome to them. Once I'm done with the whole project, you're probably welcome to any leftover...
Bob, Bear in mind that my intention with these modules is to pick a few modules that are close to the state of charge of the other battery, and...
Ok, at 100mA the voltage on the parallel battery pack stabilized at 8.02 volts. I let it sit like that for a day, and then took off the charger....
I bought the toyota cruise stalk and brake switch. I think that was all I needed. I cut a hole in the back of the steering wheel, and you can't...
