Separate names with a comma.
I agree fully about environmentals. We get extreme change. Like 50-60 degrees in a few hours on occasion. The interesting thing about a Prius...
I am wondering about the pro-testing... I have asked three different parts stores in two states to check my AGM. Not One used a tester with an AGM...
Wow. Every six years? Our Gen III is over a decade old. I *am* looking into replacing the 12v soonish ;)
Our 2011 Gen III is on the original battery... so over 10 year life to date. I'm seriously thinking of swapping it out soon. We'll see ;)
For overall pack condition, I highly recommend the Dr Prius app. It does work as a simple diagnostic. (Keep your expectations limited! This isn't...
Further comments for now: * My AGM (12v) battery is definitely wayyyy weak. Will replace soon. It's original (2011)! * I'm working with Jack (Dr...
I went back and reviewed a few things. It's the ProWatt 600 SW, with the remote switch. See p10 of instructions for fuse/power cable...
It's fixed. Strange things... * Meter and examination found zero issues. * First fix: I was clearing the code using Dr Prius. It immediately...
I just finished my fourth HV pack reassembly/install. First time to see these codes (P0ac0 , P0a0d) Priuschat wisdom suggests the orange...
One question: for voltage drop... do you measure at 2 min just before disconnect? That's my assumption. Another...
Too funny... I own a FLIR but never thought to use it for this. Nice. I'm not looking for "precise match"... just need close enough balance so I...
I use No-ox too. Yep, easily could have some mOhms in wires and connections. After all, my rather valuable Fluke multimeter shows 0 to 0.1 ohms...
I am realizing to my chagrin that while I can find bad modules through light bulb (high current) testing, such methods are basically useless for...
Ummm.. Volts = Current * Resistance High resistance at same current means high voltage, not low.
Something about this setup doesn't make sense: if I attach the resistor across the battery, won't Vload and ΔVr be identical? More significant:...
That's a great result! And yes, a+a are intended to be a block, etc. I was NOT specifying the block sequence. It was just low-to-high. As most...
Reporting back in... * Looks like the code tag is a winner. I don't see the center tag helping * Btot is total voltage drop for each block * I did...
My thoughts: * Not sure how you matched up modules. Given the data you provided, see my new arrangement (attached) - I sorted on vAfter - Then...
Hiya... I am going through the same. Not done yet. A few hints: * In Dr Prius, resetting codes ALSO clears any knowledge of IR (Internal...
Answering some of my own questions: 1) Found a very good pair of Gen3-specific videos on HV removal/replacement. There are nice simplifications...
