Separate names with a comma.
Looks good, I did pretty much the same about 5 years ago on our 2011. Also went with 4300K 35w, but made sure the ballasts and bulbs were DC vs AC...
Get long nylon bristle brushes meant to be used to clean stainless steel drinking straws. Sold at Harbor Freight and Amazon and anywhere that...
I think you are confusing the main intake outlets with the much smaller egr outlets in each oval intake outlet opening, which is the large ovals...
And this is what the spare EGR cooler I got off eBay looked like before I cleaned it. Unknown miles on it, but I would guess that it was from a...
Not possible to be clean at 240k... this is what my EGR cooler looked like at 120k.[ATTACH][ATTACH] .
My rear wheels always go up enough to rotate my tires on one side from just jacking from the front side pinch weld jacking point with a floor jack...
Here's a screenshot of a tire size comparison app. Stock wheel is yellow, narrower wheel with +35 offset in green. [ATTACH] Posted via the...
It should fit, the wheel face will be 2.5mm more inboard from stock, which is negligible. The inside of the wheel will be farther from the strut...
Wireless = no need to plug in anything. [emoji6] Try placing your phone on the circle and see if it charges (assuming you have a phone that can...
I believe you can feed that white wire up from below into the fusebox along the other wires in the front left corner (passenger side) of the...
Wireless charger for your phone? .
Oil will normally not flow "uphill", but air normally flows through the radiator and there are radiator fans blowing hot air, which will also help...
Oil pooling in intake manifold below the throttle body is normal without an oil catch can. In your case, you might have excessive blow by with...
That sucks, make sure they replace that driver's side wheel. Have them verify that there is no suspension damage from the impact to the wheel,...
@Half Vast, what year Prius, and how many miles on the odometer? You need might need to clean the intake manifold, and the EGR valve and cooler...
The last half of the pcv hose that goes to the intake manifold is covered in oil. Maybe that pcv to intake manifold connection is not sealed well...
Yes, I got that. However, it seems that the cyclonic oil separator is not very effective. Since the OP has an OCC as well, perhaps it could be...
Nice work, according to this article, the cyclonic oil separators aren't very effective. Less so than the oil catch can that you are using to...
130k on the odometer, definitely time to clean the EGR cooler and valve, and the intake manifold. Start changing the oil at 5k intervals instead...
Agree, you want the hoses and OCC to be cool(er) to encourage condensation of hot/warm oil vapor to liquid state, where it will drip down into...
