Separate names with a comma.
Agree, there's damage to the rocker panel area under the door. You won't be able to slap another door on it, the frame around the door is most...
OP is saying that the "warm" 4500K color output of the halogen bulbs is "yellow" compared to the "white" color of the IMO bluish color output of...
People have made pre ramps out of several 2x8s or 2x10s. They just need to be long enough so that your wheel can be lifted before your front...
Just keep your 3/4 inch hose to 3/4 inch x 3/8 inch barb and 3/8 inch tubing setup to go from the OCC outlet. AN6 is close enough to 3/8 inch to...
Yes, PCV valve is screwed directly into the OCC outlet side. I made a bracket, it's under a bolt under a bracket that holds the AC refrigerant...
I bought these 16mm x 1.5 female to 3/8 inch OD barb brass fittings off Amazon to relocate the PCV valve, to be inline on a 3/8 inch hose to the...
It's hard to use cribbing as shown in that picture because the Prius has independent suspension. That picture has a car with a solid rear axle...
Here's what I use: [ATTACH] .
They're constant pressure spring clamps. The stainless steel worm screw clamps you are using will lose clamping pressure when the hose deforms...
The hose fittings that came with my OCC had the correct thread size and pitch M16 x 1.5mm. I ended up using an M16x1.5 to AN6 adapter and a 180...
I hope everything works out for you, but that is a whole lot of tubing in that setup. I'm thinking that a lot of oil will be condensing on the...
Does your OCC have a dipstick? The ones I've seen, especially the lower cost ones, don't seal well around the dipstick threads. Have to put an...
It doesn't really dissolve oil, it chemically alters it to a soap, which is soluble in hot water. That's why it is recommended to flush your drain...
You also need to know the thickness of the o-ring as well. Either a direct measurement of the inner diameter (ID), or the actual measurement of...
It's easy to forget to tighten all of bolts holding everything together in the EGR circuit and intake manifold, also lots of vacuum hoses to...
You should have installed an oil catch can between the PCV valve and the intake manifold as well. Did you also clean out the intake manifold and...
Hmm, 90k is kind of low to have a completely, or nearly clogged egr cooler. You must spend more time than average with the ice engine running....
You should use some kind of container to collect the oil that goes to the bottom outlet. Otherwise, if you don't drain it in a timely manner, the...
No problem, took me a few days to do the same job. Didn't want to rush things and forget to put something back correctly. Still ended up...
Where are you going to put it? .
