Separate names with a comma.
ok, they have been on resistors now for 2 hrs. voltages are between 7.89 and 7.88v. i dont like the looks of this. i still have 7 1/2 hours to go....
ok at 12:15 i began connecting the resistors. starting voltage is between 8.13 to 8.12 ten minutes later i checked the voltages they are at 8.09v....
so im ok to connect one of the leads directly to the terminal without burning up the terminal? the resistor would be about 1 1/2 to 1 3/4 inches...
nevermind, i see that it will allow me to do that, i just changed the ohm values to 70 ohms. now as for the resistors, the leads on the resistors...
Bob: is your spreadsheet going to allow me to start the resistor test at 8.13v?
ok When I left for work yesterday the charger had stopped charging and the pack was in parallel it was at 8.10v. I left it in parallel and when I...
Ok so let me get this right, when I get home check voltage in parallel. then recharge til charger shuts off while making resistors, record...
Yes I was able to extract the spreadsheet. unfortunately I am at work until 9 and I left the pack in parallel. should I go back home tonight and...
also does it matter what polarity the resistors are in when I connect them to the modules?
with good modules what do you think the voltage drop should be in parallel? also with good modules out of parallel what should the voltage drop be?
at 1120 the charger shut itself off at 8.1 volts. I left the pack in parallel and disconnected and unplugged the charger. the voltage was at 8.10...
got my resistors yesterday early. i just ran over them with my meter. lowest ohms is 70.3 ohms highest 70.5 ohms. i think that will do pretty...
Ill see if I can do that and post it here. hopefully the tests reveal that all modules i received are good then next week i can replace my old...
Yes, they seem to be identical. I got my parts to make the pack a gen 1 pack so I can do my testing while it's out of the car. I.can't remove the...
ah, very true.
is it a good thing tho that since ive had this battery that the voltages are steady, not dropping, and not all over the place?
Ok i got the pack ready to be set into parallel. however home depot is closed and ill have to wait till tomorrow morning to go get some threaded...
ill say about 5 to ten mins
so after removing the resistors. what should I give the battery about 10 minutes before I take voltages or 5 minute maybe less? I plan on using...
