Separate names with a comma.
Voltages are fine. But that doesn't mean that modules are. You need to mensure the voltages under load (and maybe charge and also check capacity)...
Probably the engine is bad. Of course you could see where the oil is leaking. But that might just tell you if the engine oil leaked out and lack...
Oil change every 2 years or 6k miles is fine for oil change as long as you use the car less than (on average) maybe 1/4 of days (less heat cycles)...
Or just peel the barrier open partially from its glue. Glue stays tacky so you can just press is back afterwords. Barrier is there for a reason so...
You really shouldn't use anything other than OEM sensor as the front sensor. Front sensor is air-fuel ratio type and differences between sensors...
At least here all oils seem to have both Acea and Api classifications on the package. I've just used Teboil Diamond Carat 0w-30 as I wanted the 0w...
You can watch the values of (front) air fuel ratio sensor and (rear) oxygen sensor with running engine to determine which is faulty air fuel ratio...
Oil with Acea A5/B5 certification. That's a tough certification that will test that oil will give good protection and fuel saving over the entire...
Maybe also front end stuff for somebody. Front bumper, radiator, core support, hood, fenders, headlights etc.
Where does it leak from? Some areas like filler neck can be repaired. But if not just get a replacement radiator.
After the fault lights come on did you read the codes? There has to be codes.
It'll take slightly longer for oil to drain out. But other than that it doesn't really matter.
No it's not possible to change any of those values. Unless you would reprogram the entire control unit. Battery Ecu calculates those values from...
If the noise changes with turn it's bad bearing. Normally it's that noise when turning left is bad right bearing. But not all the time. So test by...
What I ment was that you could maybe install it wrong in lower controll arm so that only 2 of 3 bolts would alighn and with the wrong bolt holes....
Your car will work without one, but it might make a slightly higher engine noise or maybe very slightly worse fuel economy. Also if you're driving...
Maybe ball joints are wrong type? With new ones being shorter? Or they are installed wrong on the lower control arm? Don't turn the tie rods or...
A working pump does make a slight noise. If the fan and engine are off you can easily hear it in the car if parked in quiet place. If fan is in...
Probably a bad clock spring. It's the part that connects cables to the steering wheel.
Is your parking brake working properly? It should make a big difference if it’s.
