Separate names with a comma.
Somebody could theoretically rebuild engine with even smaller tolerances than new OEM. But probably not because it would be too expensive....
But OP can still use the MFD volt meter to check that charging voltage (voltage when Prius is READY) is about 13.8V or more. If it’s not then...
Red triangle is the master warning telling you that something is wrong with the car. Yellow snowflake on road light means that it’s cold enough...
If the other car has pretty bad battery and relatively high powered alternator it can give voltage spike when jumped vehicle starts. It would do...
1) Prius uses R-134a with ND-11 oil. Conventional systems use R-134a with PAG oil. Equipment that the shop used to may have been contaminated with...
There are relays for headlights so power doesn’t go through the switch. But stock wiring is pretty thin so I think that’s good idea. In a Prius...
No I meant the snow that collects there when driving! If there’s snow on windows before driving I will clear the snow from them and lights as...
That sort of kit works fine on Prius. Just connect the power to the bolt at positive power terminal in the under hood fuse box. Prius charging...
If it can snow where you live there’s big advantage of using incandescent bulbs in tail light parking lights. Heat. Incandescent bulb will produce...
Good info. For the spark plugs coper anti-seize might not be the best option as the plug is nickel coated in the aluminum head. Nickel anti-seize...
Try to move the windows a slightest bit to see if that effects the noise? Or if you lean on the door? Or something else? Try to figure out where...
No that’s just a clip. Drain plug is a bit inward from where the picture is taken. It’s rubber plug.
If you have put oil into it you should be able to get it spinning in the caliber. When it’s spinning pull it out from caliber with locking pliers...
Gen 2 Pius with rear disc brakes can have two different types of rear calibers. Do you have this style: [MEDIA] This actually is not good video...
I just used a heat gun.
Here’s what I use with jack and jackstands. Red square for jackstand. Green circle for jack.
Problem with trying to glue the panel sides with silicone (or anything else) is that the front part is bent down. So now there is a big cap...
Investing in bigger low profile jack will make working on a Prius a lot easier. That jack might not fit under the front jacking center point and...
That just sounds like a way to rust up your car.
What kind of clip are you having problems removing? I took one of the two panels off to clean under it and other I just cleared between the panel...