Separate names with a comma.
Here is one thread about that Corrosion/burn on Wire Frame No 2 Plug/Ecu | PriusChat The object being held in the hand in the pictures is the...
Verify that the OBD2 dongle works on another car. Inspect the OBD2 port connectors for corrosion or other physical damage. Did this OBD2 dongle...
First, you can probably ignore the HVAC error,that is probably the sun sensor which fails if the test is done in the shade. 12% vinegar? Pretty...
Shouldn't disconnecting the 12V be sufficient? The cells in the pack will self discharge the same whether the orange plug is in or not. The pack...
I don't get a warm and fuzzy feeling looking at that thing. Actually more of a sense of dread. The center of the lifting pillar appears to be...
Ask for the date off the battery. If it is original pass on it, if it even still works it won't for long.
Aren't there two relays under the hood somewhere which are needed for the pump to run? Maybe one of them failed. If they were pulled out at any...
Or Autel AP200. There is a complicated brake bleeding procedure which Techstream will only get through with certain OBD2 adapters, and the...
The way the door sensors work is that one side of the switch is tied to ground and the other to a line which is floating at 12V and comes from the...
Actually, it isn't. There are other components in that circuit which control the current into the lithium battery. Minimally something like a...
That is not "in parallel" with the conventional meaning of that phrase.
If the entire wiring harness was fubar'd the car would not have started. Maybe check the OBD2 with a voltmeter and verify that pin 16 is 12V when...
Placing batteries of different chemistries in parallel seems like it could go badly wrong. They don't charge up the same way, they don't...
Project farm tested an assortment of small handheld 12V battery testers: [MEDIA] Unfortunately he didn't test the one I already own (Viking...
Broken engine or transmission mount? (Grasping at straws here...)
Sure. But on other vehicles as the splines start to go there are often other symptoms. Things like difficulty shifting or funny noises. Then...
Has the OP checked the VVT system? If the solenoid gets sticky it can apparently cause rough starts some times. Looks like replacing that...
To be honest I'm not even sure that this car has a conventional single nut holding the flywheel on. Looking at the first few minutes of this...
One piece of 2 x 10 on each side is high enough to get our Harbor Freight 3 Ton low profile rapid pump going. The first couple of pumps the...
Is it possible on this engine for the flywheel nut to be a little loose? If there is any play at all one can imagine that the flywheel might...
