Separate names with a comma.
I can honestly say that the Gen 3 Prius/Prius v have one of the worst rides as far as vibration and handling bumps and rough road surfaces. It is...
Yeah, I jacked her up and all of the CV boots were OK, I didn't see any holes/splits, leaking or grease slung around anywhere. I guess I'll let...
Yes, I believe I notice it when making right turns, and it does sound like it may be coming from the left, driver's side. SM-G781V...
On further thinking, I believe the muted clicking, ticking sound is coming from my CV joints. It's happening when I take turns at low speed, yes,...
I installed AC HID ballasts and bulbs over 10 years ago, our 2011 never had the harness recall work done. HID ballasts can take a very wide range...
Also, 2013 and you have changed the brake pads and rotors 5 times? WTH, do you rally the car? Our 2011 at 144K is still on the OEM brake pads...
Cusco Front Sway Bar For Toyota Prius 2010 - 2015 [ATTACH] SM-G781V ?
Doesn't a front sway bar go underneath, on the suspension, not in the engine compartment (strut tower brace)? SM-G781V ?
I know it was an old post, but the rod on the left is the new one, so pretty sure it's straight. [emoji6] SM-G781V ?
How thick is the sway bar in mm (diameter), and what is the OEM sway bar diameter in comparison? There was talk before about installing a front...
Our 2011 Prius 3 at 144K is at the point where the accumulator pump is running about every 15 seconds, but it hasn't thrown any codes yet. It...
I never did like wheel covers, same with these. That looks like a very large offset on those wheels, what is it 55mm? At least the wheels look...
Your EGR valve is most likely OK. You need to use an impact driver like this to remove the tight screws holding the EGR valve together. Once I...
Easiest way to tell is measure the voltage, or lack thereof at the jumper terminal. You do realize that only one side of the jumper terminal is...
If you have access to an obd2 scan tool, the more advanced ones have steering angle sensor (SAS) adjustment available if I recall correctly....
I've installed neoprene seat covers from EKR on two Subarus, nice and thick material. I highly recommend EKR if you can find a listing for custom...
The aluminum housing turns down, then it hits a positive stop making it impossible to tighten further. Even if it is tightened to the stop point,...
Agree, it's late. Our EGR cooler at 120K was very dirty and about 75-80% clogged with rock hard carbon and oily gunk. I swapped in a pre-cleabed...
To the OP, this Amazon listing includes the oil plug at the top, and o-rings: Oil Filter Housing Cap Assembly with Oil Plug Drain Compatible with...
Seems I'm the only one who advocates for changing the plastic oil filter housing, that swells with exposure to heat and oil, making it difficult...
