Separate names with a comma.
Is the oil on the boot or ceramic of the plug or on the tip that goes in the cylinder?
Does the cabin heater blow hot air? If not, then you are still low on coolant, that can set the code. It is very difficult to get all of the air...
Next step should probably be a compression check.
If you just had tires replaced, the most likely issue is that the tire shop broke one or more of the sensors. I have not heard of may confirmed...
First, to shut the car off, hold in the power button for longer than 3 seconds. As to the problem of it not shutting off, it sounds like the...
Yeah, 50mpg for 120K miles. Why would you want to switch from the OEM plugs?
LRR = Low Rolling Resistance: Means less or no mileage hit once the tires break in.
Probably the best all season tire to use in snow is the Nokian WRg2. They are LRR, not too noisy, and have excellent snow and wet traction. Expect...
I would take an experienced alignment tech that really knows what he's doing with basic equipment over a minimum wage oil jockey with a fancy...
The rotation does not "cause" the issue, but will spread the damage to more than one tire. Example: If LF tire is wearing on the outside due to...
If you or your mechanic has been rotating the tires front to back only, then it is indeed possible that you have too much positive camber (top of...
Cupping wear on tires is usually caused by either worn struts or very bad tire balance. Since you did not mention any vibration, I would suspect...
Like above, sometimes water in the tire from excessive lubricant use upon mounting and/or a compressor that is not drained regularly can cause...
Agree with above. Most likely low coolant level.
Good luck, and please report back their findings!
Join the club, 10% Ethanol is pretty much the only type of gasoline available in the Northeast. Surprised it took this long to get to "corn country."
You need to add at least 3 gallons for the car to recognize it and start, unlike most vehicles. Also, the fuel gauges are notoriously unreliable....
I would double check the voltage in the "Ready" mode as well. Assuming that is significantly higher than what you are getting with the vehicle...
Maybe John can comment on this, but there's really no point to reset the calibration without getting the alignment correct and straightening the...
Thanks for the pics! If I am correct, I don't see any polished areas or scuffing on the cylinder walls or the pistons. Do the oil rings (the...
