Search Results

Search Again
Page 5 of 10
  1. mainemanx
    Post

    My new PiP with RAV4 side molding

    I wuz wrong. Allannde is absolutely right! They're from the current generation RAV4. (Notwithstanding the current generation RAV4 IS the...
    Post by: mainemanx, May 2, 2012 in forum: Gen 1 Prius Plug-in 2012-2015
  2. mainemanx
    Post

    For Sale- Gen III LOWER BODY SIDE DOOR MOLDING

    Sold :thumb:
    Post by: mainemanx, Apr 29, 2012 in forum: Private Sales
  3. mainemanx
    Post

    Don't buy Weathertech mats for your 2012

    - Full set of blacks, 9 years in our 2003 CR-V... slush, snow, ice, grime, and goo... haven't leaked yet! – Full set of greys, 1 1/2 years in...
    Post by: mainemanx, Apr 29, 2012 in forum: Gen 3 Prius Accessories and Modifications
  4. mainemanx
    Thread

    For Sale- Gen III LOWER BODY SIDE DOOR MOLDING

    – New, open-box. – OEM Part No. PT29A-47100. – They look great, but no longer needed, never installed. – Four-piece, injection-molded,...
    Thread by: mainemanx, Apr 28, 2012, 2 replies, in forum: Private Sales
  5. mainemanx
    Post

    My new PiP with RAV4 side molding

    P.S. I don't think it's been mentioned, but the RAV4 moldings are from the previous generation, not the current generation RAV4. I think they look...
    Post by: mainemanx, Apr 18, 2012 in forum: Gen 1 Prius Plug-in 2012-2015
  6. mainemanx
    Post

    Curt Tow Hitch Install Finished!!! if only 30 minutes

    According to eTrailer.com, max tongue weight is 200lb.
    Post by: mainemanx, Mar 11, 2012 in forum: Gen 3 Prius Accessories and Modifications
  7. mainemanx
    Post

    Multimedia upgrade on a non JBL 2011 prius II. low cost minimum fabrication

    Wow! And all from eBay! I, for one, will be following your progress. Gambatte! :cheer2:
    Post by: mainemanx, Feb 18, 2012 in forum: Gen 3 Prius Audio and Electronics
  8. mainemanx
    Post

    Yet Another Shark Fin Antenna Thread--My Experience and Review

    Yes, not to worry. If you (at least somewhat) followed the instructions, it's not going to fall off. In fact, I recommend installing it and...
    Post by: mainemanx, Jan 26, 2012 in forum: Gen 3 Prius Accessories and Modifications
  9. mainemanx
    Post

    Has anyone put on Weathertech Visor Vents lately ?

    Fronts are no problem. I didn't use the clips on the rears, but simply replaced Weathertech's tape with 3M double sided tape, 1.5 inch strip front...
    Post by: mainemanx, Jan 16, 2012 in forum: Gen 3 Prius Accessories and Modifications
  10. mainemanx
    Post

    Chrome door handle

    How about black chrome?
    Post by: mainemanx, Dec 29, 2011 in forum: Gen 3 Prius Accessories and Modifications
  11. mainemanx
    Post

    Service Bulletin for Engine Knocking at Startup T-SB-0204-11

    Ask; they might do it regardless.
    Post by: mainemanx, Dec 29, 2011 in forum: Gen 3 Prius Care, Maintenance & Troubleshooting
  12. mainemanx
    Post

    JDM Prius Steering Wheel

    'Was able to talk down my winter wheel/tire people to thirty bucks for tie rod end adjustment to align my after market wheel... 7.8k miles on...
    Post by: mainemanx, Dec 12, 2011 in forum: Gen 3 Prius Accessories and Modifications
  13. mainemanx
    Post

    Final decision for aftermarket radio

    Looks great! You've thoroughly analyzed it... go for it!
    Post by: mainemanx, Dec 5, 2011 in forum: Gen 3 Prius Audio and Electronics
  14. mainemanx
    Post

    JDM Prius Steering Wheel

    Yep, same here... a few, carefully balanced bumps and off it came. Not once, not twice, but three times as I removed, replaced, adjusted,...
    Post by: mainemanx, Nov 25, 2011 in forum: Gen 3 Prius Accessories and Modifications
  15. mainemanx
    Post

    Success - Polk DB651s in Factory Enclosure

    "A turkey in every pot, an amp in every door," eh? Plus, the front doors are already wired for 12v ;) But point well taken; there's lotsa'...
    Post by: mainemanx, Nov 24, 2011 in forum: Gen 3 Prius Audio and Electronics
  16. mainemanx
    Post

    Success - Polk DB651s in Factory Enclosure

    Ahhh... great to hear you had a quality improvement. But where are you guys gonna' mount an amp? - Behind the dash. Hard to get at if you wanna'...
    Post by: mainemanx, Nov 22, 2011 in forum: Gen 3 Prius Audio and Electronics
  17. mainemanx
    Post

    Level II, Sony XNV-770BT Installation

    Right side S/W buttons were unaffected by the Sony.
    Post by: mainemanx, Nov 14, 2011 in forum: Gen 3 Prius Audio and Electronics
  18. mainemanx
    Post

    Level II, Sony XNV-770BT Installation

    As recommended by LovingLife and several others, I got: "Metra Axxess ASWC Universal Steering Wheel Control Interface (Black)"...
    Post by: mainemanx, Nov 14, 2011 in forum: Gen 3 Prius Audio and Electronics
  19. mainemanx
    Post

    Success - Polk DB651s in Factory Enclosure

    Dear wife says dinette wainscoting takes precedence :eek: In the meantime I've wandered off the reservation and (fronts only) am currently...
    Post by: mainemanx, Nov 9, 2011 in forum: Gen 3 Prius Audio and Electronics
  20. mainemanx
    Post

    Rear Facing Camera - Text Backwards

    I wish there was an indicator, a light, a beeper, or something that let you know when a thread is in jest, a lampoon, or otherwise not serious. I...
    Post by: mainemanx, Nov 8, 2011 in forum: Gen 3 Prius Audio and Electronics
Showing results 81 to 100 of 190 Next >
Search Again
Page 5 of 10