Separate names with a comma.
Yea thanks.....i will check into that. But where does it connect?
The car had just been turned on, right after oil level check. I checked it the same way i psriodically checked kt on my 09 Prius. Level was full...
I really need to know what state of charge of main battery is! 200.00 is nothing compared to what repair of the main batt will cost. I looked up...
I only have a fluke meter and charger. Where can i get a load tester?
absolutely. Was running perfect. Continued running at idle perfect after putting cap back on. (I saw that there was good fluid circulation). Shut...
The engine is running for a very short time before the hybrid control system senses something wrong and shut down everything. It will fail and...
I have had a 2009 prius for 6 years. So i knew about the importance of inverter coolant pump working. It failed on my 2009 prius, and i replaced...
Is there a way i can check voltage of hv batt pak with fluke? Without having to take rear seat out to access it? If "state of charge (all bat)" is...
yea, same one.
A few times, like the time i tried to reset system. by pulling white wire out of fuse block for 2 minutes and then reconnecting it, the engine ran...
Yes car was running fine. I bumped nothing else in engine compartment
I need to get really good repair reference i guess to have the slightest hope of figuring out what is wrong. Is a Bently manual sufficient or do...
Yea prior to taking inv coolant cap off and dhring check and maybe a minute . after it was running fine. Then i shut it down. Perhaps 10 minutes...
Yes it over 3/4 full. I did not notice any snowflake symbol. In the hybrid control sytem field. Does this appear right under the code or the...
I noticed that this new 2010 Prius 3 i got with 140k miles was only indicating 4, maybe 3 bars of charge on hv battery pak while idling for some...
Have a 2010 prius 3 with 140k miles. Its showing the check hybrid system message. Have tried to get car started and failure cleared by charging...
OK....thats probably what is wrong. I didn't seat either of the bulbs in correctly perhaps. As for the RH high beam problem, I disconnected the...
