Separate names with a comma.
Hi! In the process of rebuilding the engine after a head gasket change. Followed gasket masters video. When I took off the rocker arms and the...
Yeah those raised edges were like all flat with the rest at the beginning so I tried to atleast make those pop out a little more
Yes both of those are already done :) My EGR is prettyyyy good now and my intake, I mean I soaked it, pressure washed it, cleaned all the...
Gasket is going on this week (had some delays with shipping and all). have a Toyota mechanic friend coming to do timing part. im trying to clean...
Well I sure hope they did haha they charged me 180$. It is much cleaner than when I brought it in, and they said they performed the tests...
When I looked back at the pics I agree with you I think I had them and they weren’t visible or as noticeable. I’m going to assume if they were...
Exactly what I did for the bottle brushes! Pinesol I read about online, didn’t know! I rinsed it super well and used brake cleaner instead. I...
I ended up finally getting it undone; clamp may or may not be reusable, not sure yet lol but will try ordering from elsewhere than Toyota! Let it...
Hi!! I googled and searched the forum already; saw the steps to removing this pipe that’s connected to the intake manifold cover, but every...
Yeah I went to the auto shop today and saw rethreaders- never even knew that was a thing. I will ask the machine shop, if not I was going to see...
My EGR cooler, the two little ends on the outlet, where the stud bolts drive in, are completed corrded due to rust; like corroded to the point of...
This had exactly what I needed. Ended up cross-referencing it with information I found online, and matches throughout 3 different information...
Head is currently at machine shop. In the mean time I'm reading and rereading the manual and watching videos and writing a step by step guide of...
There were big spots of sealant in those locations, but a fine streak of it at some other places. There was also a very steady and uniform streak...
You've given me enough reading material to last me all evening; going to nerd out on this now Would a machine shop check all the tests...
You've given me enough reading material to last me all evening; going to nerd out on this now
Thank you for this!!
Head bolt is coming out tomorrow- I was missing the transfer punch so needed to order it. I'm surprised there isn't much spec'd to put near head...
I removed my head gasket and am ready for re-installation. I did the piston tests to make sure none were broken (used gasket masters video)...
