Separate names with a comma.
After much searching and testing (as all closed at about 180-200F) following both (all 3 parts in our with 2 same # salvage pulls) both #'s tested...
Found it & picture matches it exactly! On a long shot searched NAPA android app. A little pricey so still trying salvage 1st: Coolant Temp Sensor...
If that does not work out then I will plastic welder epoxy the connector body back on and solder the terminals back (not necessarily in that...
That all I can find also. Going to have the wife take two my young adult sons to the local pull it your self salvage later today while I am at...
Your trans has wrong fliud in it she is suffering accelerated failure from that bad mistake and its not gonna be covered. They are all gonna play...
Went to drain the old fuel out before starting her up & pour coolant in inveryer and my boys doing pre pour assembly completion leak checks on our...
Forgot to answer the cell question. My OP or origional post, should have stated IIRC that 4 cells were bad and had low volt reading from between ~...
BTW, i plan on permanently installing the oscillators on both my Prii auxillary batteries as that poor little batt seems over taxed a bit in this...
That thermometer is fine. I used a Klein MM200 about $50 is the minimum I would recommend. Oddly the pad printer at the factory mis marked it...
That is the correct torque for fastener sizes in that dia range for steel alloy for electrical installations which are a bit by thumb or most...
JTM2955, You REALLY do not want to know. I am a master auto tech & avaition A&P tech with avionics installation & troubleshooting training &...
Just to be sure does anyone have sound reason to use anything besides the 48 in lbs torque on the Gen 2 HV batt cell terminal lead nuts that I...
Weird the number changed when copy & paste. But I did get correct one ordered for about $ 15 on ebay.
Yes, that is it non HID. Thank you valde3. It was a terminology problem parts catalog calls 832-282-3101 a headlamp socket cover. That site does...
Re: Our "06 Driftwood Pearl total front end bought wrecked for $ 1200 rebuild is about 90% done: But we bought a DR LH headlight assy and swapped...
