Separate names with a comma.
So I checked and my brake lines were loose, I didn't tighten them enough. Buddy pressed on brakes and brake fluid leaked around them. I tightened...
Yes smoke from under the hood, couldn't tell where it came from exactly. I see, thank you. I thought there were empty places still even after...
Hmm I hope fluid leakage. I will check my connections today
I am? Accident, am I able to move it?
Hey everyone, You may have seen my other posts. Replaced ABS in my 2007 Prius but couldn't use Techstream to bleed for some reason and bleeding...
I only used a hand wrench to tighten all of them, I may have tightened more than needed so I may loosen them a tad and check. I'm guessing seated...
Also there was some brake fluid on the top of my ABS, maybe from when I did the replacement but I'm gonna try to undo and redo the top brake line...
Yeah I pulled them the blue ones. Huh, so it doesn't mind if you have them out or not for your car when you run the program. Then it is either low...
Is there a certain power level it should be? Mine read 12.47 when power was off. I can charge it inside but I don't have a portable battery...
If my 12v is good then I don't understand why Techstream won't let me run the brake bleeding program. I'm pretty sure I have the correct relays...
My 12V reads 12.47V with the car off, is that charged enough or no?
Why do you want the relays out while you bleed the brakes manually? I had them in while bleeding. Once the buzzer sounds, my brakes are...
How can I tell if the part is bad? When my last one went out, the brakes were completely gone, it didn't behave this way, so that's why I think...
Hey all, So I finally got a new, albeit used from eBay, ABS module in my 2007 Prius. Doing it myself since mechanic who said I need a new one...
The nut cracker worked, just had to use it a bunch of times! Got my plugs!
Not sure but from what I can tell only the nut is turning but I'll keep it in mind when I work on it today
Yes
They rotate separately for me. I tried that a little yesterday, hard to get much pry on it but I'll try again since it may work, thank you. If...
Definitely rub marks but the hex is turning. I made sure both when I used the impact wrench and I tested with a hand wrench, used both the 12pt...
It is loose, will turn but then get stuck a little then turn loose again, just won't come off the thread at all. If stays in the same position.
