Separate names with a comma.
No pics. maybe next time.
HI FWD, This is the readme.txt file that is supplied with the latest BASIC program. It sounds like you never bothered reading it. If you do...
Go I did not notice the specs. The top says the cell weight is 500grams which is about right but the bottom says the weight is 41.5 grams which...
At the high current but low voltage I would expect the copper tab to melt and open circuit (like a fuse) with little/if any explosion at all due...
I have just found a listing on Aliexpress that shows the A123 cells with the zipper fuse. At $19.80 each and it includes a zipper fuse although...
The last time I checked my A123 battery 20ah pouch connections I noticed that the copper tabs had oxidised despite being covered by compressed...
There is no guarantee. I would breadboard a circuit using pushbuttons and resistors to simulate a CCS. According to my manual there are four...
I have been following this thread on thebackshed. I am not keen on having to modify my Lilliput screen to expose the touch screen resistance...
I am now adding F9 - DATA LOGGER which will start recording data of all the variables into a CSV file "B:DATA.CSV" on the micro SD card. Then...
The quote above comes directly from the PacificEV website Pacific Electric Vehicles
Hello Visitor, The best option for somebody with no technical understanding/ability is the Pacific EV BMS which is almost a direct replacement...
You should be very wary of the BMS16D. Keep an eye on cell 16. The BMS16D draws less power from cell 16 compared to the other 15 cells. It is...
Hello Mike, I guess you do not have much choice for a DC Converter supplier but I can tell you first hand that I have already done what you are...
The only thread I am aware of is this one but it is for a 4kwh PIS kit. PIS 4kwh PHEV kit assembly and installation odyssey | PriusChat Parts...
That is strange as the standard for Pins 6 and 14 on the OBD connector is J2284 - High-speed CAN (HSC) for vehicle applications at 500KBPS which...
Bummer. The problem with this approach is that once it is done I cannot use the touchscreen with my original Canview V4.0 by Norm. Actually I...
Hi JDH2550, At this point I would like to connect my Lilliputt touch screen/7'' LCD monitor to the RS232 port of the Duinomite Mega for touch...
I have added another page for CANbus data analysis. As shown below. [ATTACH] The first line of data is live and the following lines are recorded...
Why not get the FET shield board from EBay instead of the relays board. I am sure that Norm is using FETs on the BMS2 instead of relays. I guess...
I have added a PSD page at this post : My Duinomite Mega Canview V4 equivalent Project | Page 13 | PriusChat
