Separate names with a comma.
VERY helpful, all of the above!
Good morning zsolar, I read your story of changing a gen 2 trans over the weekend and liked your tone, "it was a fun weekend project ..." I am...
Hello zsolar The trans on my '04 went away from me last night. Pulling into traffic there was a snapping sound and rattling under the car. It...
The AM1 fuse was the only one that had the effect of reducing current draw. I agree that it was likely "something" in the ECU was stuck, so to...
Patrick it looks like I have a 2004 model according to the pdf I found online - see below Below is a visual summary of the AM1 fuse location and...
JC91006 I do use the SKS key, always Sam while pulling the fuse/relay under the hood and in the cabin on Sunday, the amp draw was about 5 amps....
Yesterday morning I was on my way to church only to find a very dead 12v battery and no response from the car as I pressed the start button. I...
My doughnut gasket was making the growling on acceleration noise and throwing the P0420 code. I convinced myself that the CAT had to be replaced...
Update: Along with Manhal's suggestions I found another guide here in the forum, this list strongly suggested changing the trans oil, which has...
A few more points about the Throttle body rebuild: All phillips screws were seized to the extent that the phillips socket would strip before the...
Update! Since getting the battery install right things moved along pretty well. The other night after getting it to run, 10 minutes later, the...
Always look for the simple stuff! The battery I got from the salvage yard had been disassembled at the safety plug, I didn't notice the little...
OK dolj, this is very important. Can the HV battery be charged thru the orange safety plug if it was modified? One more question: will the Brake...
Hi Eric All cells looked normal in that there were no irregularities, all cells looked perfect, there were no drainage stains under any cells. I...
I'm home Tried the patient approach per Don, brake pedal depressed, wait 15 seconds, press the gas ... no start. I played with the display a bit...
Don you are correct, I am trying to slide the shift lever into drive after just a few seconds. I will wait longer for this. On a different note....
Don I am at work, how I wish I could prove this! I will try in a few hours, thank you.
In my post #23 is a photo of the dash lights, do you see anything that would stop the start sequence? My start sequence is as follows: insert...
See my post #26
dolj the graphic helped, I did not have the lock slide down. But even after pushing this down the start button is still not green and I have no start.
