Separate names with a comma.
Bottom mounds installed. I used stainless hardware. [IMG] [IMG] Upon removing what was left of the old fan switch, the pins were still in the...
Here is the site I used: 2003 - 2009 Toyota PRIUS NHW20 OEM Parts | U.S.A. sales region, , 917612 A site a regular consumer might use: Select...
Here are pics of the clip nuts for mounting the radiator to the radiator mounts. Part# 1649320310 Washer - Plate Radiator [IMG] [IMG] Here they...
There seems to be two parts store versions, one for the consumer that doesn't show as many parts, and ones for techs that do.
A lot of online Toyota part sites only show this: [IMG] I found this: [IMG] Here are the part numbers. The 8 bolts that hold the individual rad...
The 1.5 Engine used in the Prius C is pretty much a Gen 2 engine with some changes, but the intake manifold itself will bolt right up. The...
Too rusted out to use.
Replacing the old one, the new one does not any hardware to hold it together. There should be two nuts installed on the top and bottom to hold it...
I have techstream, but I have a Win11 laptop and can't seem to get it to work on it.
Personally I think the entire Gen 2 throttle body design is goofy as hell. Why? The throttle body in a Gen2 Prius is pretty much the same...
PM sent,
I replaced my radiator and accidentally broke the old one. Both coolant sensors are under $10 at Rockauto. The fan switch is $75! It looks...
Also noticed the engine is MUCH louder in drive than it is in park, and that is with my foot on the brake.
Took the actuator out, tested it with a power supply. Works good. Checked the little filter for it, no issue. Put it all back together and the...
All new motor mounts. Nothing visibly moving. PXL_20241007_175756668.mp4 It almost sounds like axle shafts, but those shouldn't move at all in...
P0016 is a timing DTC code. The VVTi actuator is an aftermarket from Autozone, could this be at fault? Engine ran fine for 30 straight minutes,...
Well I figured it out. At one point in time someone took the throttle body apart. The arrangement of the throttle position sensor is super...
I keep getting P0122, P0222 and P2315. Which results in P0A0F "engine failed to start". All related to the throttle position sensor. I've taken...
[IMG] Port for the oil pressure switch. Accidentally over tightened it. Spoke to a few engine builders, they said it needs to be tig welded, JB...
PC, go here: Leaking oil pressure sender. | PriusChat My question is, if the engine isn't coming to pressure due to this leak, would it just shut...
