Separate names with a comma.
Just ordered a Duinomite Mega locally from Dontronics in Australia. It comes with a case for AU$16.40 extra. Firstly i will set it up just for...
You could buy these ECUs from a car wrecker for a lot less. No guarantee that the ECU's are causing your problem.
Yeah, can you tell us the price. I think you are getting 10kwh worth of RFE. Guessing that you are getting about 140 cells x US$30 ea. = $4200
What are you planning to use for a BMS with your RFE packs. Options- miniBMS - I use these. Enginer's BMS16D, Enginer | Solar Powered Prius...
My bad. It can handle up to 1Mbps. Reading up the manual. Seriously thinking of replacing it with my Canview V4. Need to figure out how to get it...
It shows a Lillyput touch screen working with a Canview V4 from Norm at www.hybridinterfaces.ca. The screen shows the ICE temperature.
The value of 28 hex (x03c8) is not the ICE temperature (x0039). It is inverted. It correlates to a ICE temperature of 68degC or higher. If you...
I have been observing the x03c8 Canbus message. The second data byte varies between 34(hex) and 28(hex). It correlates with the ICE temperature...
Hi Jacek, Can it be modified to start bleeding at 2.5v. Thanks.
How easy would it be to replace a bad cell?
Need better photos. Focus is bad. They need to be taken closer using the macro function. Cannot read SMD resistor values, cannot trace PCB...
[ATTACH] I extended the wires and added a toggle switch as shown in the photo above. It is a tight fit.
A bleeding board is a BMS for a single LifePo4 cell, in this case it is a A123 20ah pouch cell. It just top balances but it has no voltage...
Maybe start a new thread and post a high resolution photo of both sides of PCB. Try to draw a electrical schematic diagram from the photo. Maybe...
We won't really know until somebody actually does this project. It could be a race between you and JHD to find out for sure. Or you could ask pEEF...
During my drive to work with the ICE enabled (data file attached) I have recorded 1609 spurts of canbus messages for 0348. Just looking at the...
Should set your end voltage to 70cells x 3.65v = 255.5v You may be able to modify each one of your BMS modules to start burning power at a lower...
Congratulations. You could have done the mod a lot earlier. It looks like in your photo you have run two wires outside the case to make it more...
I was just looking at the Duinomite Mega manual http://www.olimex.com/dev/DUINO/DUINOMITE/DuinoMite-UM-1-03.pdf , It has a high level language...
