Separate names with a comma.
The two bare wires would be the 12V pos and neg. Three RCA connectors. Red and white RCA plugs are sound input - left and right speaker. There...
My Canview V4 must be used with a VGA monitor. However the earlier Canview V3 can drive the MFD. I think Mr Plugin is using this v3. Send Mr...
VGA offers the best screen resolution for this Duinomite Mega package. It also has a RCA composite video output but it has a lower resolution than...
...
The ICE is rated for a maximum of 52kw at 4500 rpm. So why should the Torque reduce? Your graph peaked at 48kw so there is still 4kw of grunt left...
Planetaire definitely has a 2nd Gen Prius as he is using a BMSplus which only works on a 2nd Gen. I think that the power produced by MG1 does...
Today I drove 142 km in mixed mode on a Sunday drive. I got 3.0 l/100km fuel economy for the 142km trip. I normally drive in forced EV mode. It...
This guy claims that Frank used a hacked version of mmBasic 2.7. So that means that the only difference between mmbasic 2.7 and DM basic 2.7b are...
The converter is a trickle charger about 16 amps at most. Every now and then the battery ECU does a SoC check based on voltage and adjusts SoC...
It turns out that the Converter temperature is rxData(2) for frame 21. So if rxData(0) = byte 1 then it is correct. I now get a normal reading for...
The battery ECU needs to be fooled. It is programmed to think that there is only a NIMh 6.5AH HV battery. The SOC becomes really low and starts...
Thanks. I totally forgot that there is a 50 degree Celcius offset.
Here is a copy of JDH2550 instructions in Dutch. Maybe it will help you....
I am getting readings as high as 108 degrees Celcius and usually aroud 45 degrees Celcius and temperature changes quickly. Not sure if byte 3 of...
Yes it has been done before. A whole thread on it using a BMSplus or BMS2. For a Prius Generation 2 only. Planing CanView and BMS+ conversion...
Most likely JDH2550 new CAN commands can be built with either mmbasic or DMbasic source code. Just need to follow the instructions JDH2550 wrote....
I am sticking with using mmBasic merged with CAN commands. It's simplicity makes it user programmable allowing the PHEV user to customize the...
Thanks.
I have made up an adaptor so I can do a clean swap between my Duinomite Mega and my Canview V4 if needed to. See photos.
Does anybody know the address for the converter temperature using a CANUSB or an ELM, (not ScangaugeII). I know it is in the 07EA 21C4 memory...
