Separate names with a comma.
I got 92-95 in maintenance mode. Maybe I shouldn’t have made that second hole in the thermostat when I cut the jiggle pin since I’m on the east...
I’m getting the following fault codes: P0102 P0113 I guess clean the maf sensor and change the air filter P0403 trying to repin the egr plug...
when you bought the American version of the engine coolant outlet flange did you use the same gasket that came with the motor or did you buy a new...
Put a new after market thermostat in, cut the jiggle pin and made a secondary hole like you mentioned in your thread when you did the swap. I...
Just bought a thermostat housing. Your patience on the stupidity of this question is appreciated. Is the brass part in this thermostat the jiggle pin?
move had issues with the thinkdiag app. It reads the engine as a 2016 and then gives no information on any code. If I put the 2010 vin number in...
So when I go faster than 40 mph it overheats. As soon as I get off a highway and go under 50 it stops overheating
It was just really loud whirring. The engine has a new 2010 water pump and new gen 3 egr valve and cooler. salvaged exhaust manifold and gen 3 in...
just drove it about an hour and it started overheating. When I pulled over the water pump was making a horrible sound. It’s a new 2010 pump so...
Thank you to everyone who helped me on this thread. Priuschat turned this failure to a success in my eyes. I'm hoping the car continues to run well.
Went back to the car and did everything you explained. I got heat in the cabin and no overheating issues. Coolant went from the b line down to the...
Hybrid Doctor in Fredericksburg VA?
Should I drain the coolant out and start again? I filled the degas bottle all the way to the full line only and didn’t get any coolant on the...
Been getting heat in the cabin and it’s not overheating. It’s been running in maintenance mode for 20 minutes. Check hybrid system warning is...
so far I’m getting steam on the clear hose connected to the bleeder. Starting to get heat in the cabin. it’s not overheating but I don’t trust the...
I got a new 2016 engine coolant outlet flange and ditched the Aisin pump/valve/grey piece. I couldn’t get the egr 3 in without removing it. I...
don’t know what a jiggle pin is. I’m kind of lost on where he ran the clear hose to? I guess a bucket?
what is the jiggle pin you’re referring to? this is making a little more sense. It’s the same concept as bleeding new chiller lines in a...
yes, I have a bleed valve.
It ran in maintenance mode with the heat on high and started overheating. The check hybrid system warning also appeared again. I recall the heat...
