Separate names with a comma.
You shouldn't need to worry about the gas or the oil sitting for 6 months. If you feel the need you can change the oil after fitting the new battery.
What is your driving pattern with this car? Like, how many miles a day and how many days a week are you driving?
P0A93 is an ECM code and will switch on the MIL (message information light aka the check engine light). If you had the Master Warning Light (Red...
Yes, they are NiMH. Grid charge at 350mA until 235 V. I would actually do a full top balance charge if it were mine. You can search the forum...
These misunderstandings are not unusual for the new Priuser. Putting the stick in “B” to get max re-gen is actually untrue. You get less regen...
You're just asking for trouble. To this point, the battery has given no indication that there are any problems in that area, so you risk muddying...
Yes, it does and at that level, the car will not attempt to start the engine. The battery needs to be charged up to 210 V or more so one or more...
This DTC is output if the Hybrid Vehicle battery is depleted or the Hybrid Vehicle control system has a malfunction. I'm going to go in the...
... and you need to drive the car for 20 mins or so to activate the transmitter.
I think it is more likely the 10-digit (hexadecimal) number: [ATTACH]
Generally, when they get to 1.2 V below the other that's the end of the road for that module. They need to be similar in capacities. Voltage...
It is quite normal to stay on the first pip for a long while and at 250 mi it is probably getting to the point where the first pip will disappear....
Someone on r/ ask a mechanic is blowing smoke – it can't.
That is a ½" FOOT-lbs torque wrench. You want a (usually) ¼" INCH-lbs torque wrench. You will not be able to set 4 ft-lbs (48 In-lbs) on that ½"...
Scanners don't tell you whether a part is bad or not, they only tell you of a problem with the circuit as a whole. It is up to the human involved...
Why the negative Nancy? The ABS module maybe, but as for the others there's no precedent for those to fail early.
For the benefit of other people who happen upon this thread hoping to find a solution, this procedure does not reset the "Check Engine" light, it...
Not exactly. There will be a cover on it and the frame for the electronics with some components in it. The components that are not in it you...
You might be able to do limited bleeding to move fluid through the lines to each corner but you cannot bleed the actuator without Techstream or...
Did you check the 5 A fuse in the block attached to the 12 V battery ⊕ terminal? The owner's manual details the procedure to operate the hatch...
