Separate names with a comma.
Hello everyone, I have disconnected the DB8 balancers. I used a 6v car charger to charge the cell that went low first. I did this 3 times for a...
Hello Everyone, I have been running this system for quite some time now with no balancers. I have pulled a little more charge out of the cells...
Hi Kgall, No, you are incorrect. All of this engergy does go back into the Prius HV battery. The Pruis is very good in recapturing this. Yes, The...
Yes, At this point it is very important to have the CellLog data. Have you loaded the Software onto your computer? Remember to only plug in one...
Hi Pb, Priuschat is not where you find experts for the Enginer system. Be aware that you will get varied responses. Some will be good. Many will...
Hello Chrysotile, Sorry for some of the insensitive posts. I do fully believe this. I also have done much research into the San Diego incident and...
Hi Pb, So we will always have some variation from cell to cell. The question is if you are getting good net performance from the entire pack....
Hi Pb, When you take a little out of cell 6 you effect its whole range. You cannot take it out of cell 6 at the top with out it effecting cell 6...
Hi Pb, I don't think so. The charger draws 15a at 120vac. So the inverter would need to be a 2kw inverter and so it would draw 180 amps at 12v....
Hi Pb, Is cell 6 also going low when you get to full discharge? To be sure you are seeing full discharge you need to run the system till you get a...
Hi Pb, Yes, this sound normal. You will always have one cell go high first. Do a discharge cycle and a charge cycle and then Email me that data...
Hi everyone, Here is a chart updating my system performance. [ATTACH] I or my wife drive the car 4-5 times a week. The average for both of us is...
Hi Adric22, Did you keep the car Electric only with light foot peddle or did you do some kind of an EV hack in addition to the Enginer kit?...
Yes, PluginPlanet is listed http://www.enginer.us/installers/ I have done Emails with a person in the UK that had an install before the first of...
Hi Draheim, I block a little more agressivly. I have a ScanGage to be able to see the ICE temp. Is your care parked in a garage at night or is...
Hi Draheim, I grew up living at 8034 NE 13th street so I know your hills. I drive a 2010 in Vancouver Wa so our ambient temperatures are similar....
I have done this. 238v is in spec, but in my opinion too low. I set mine at 242v and it runs fine. Be careful, 5v for one turn is not accurate....
Hi Rick, Yes the Enginer kit will work with a Camry. I know it has been installed in a Lexus which is very similar. I suggest contacting the...
Yes, Enginer has an authorized installer in Sanford. http://www.enginer.us/installers/ Thanks, Dan
Hi Hobbit, If the Enginer converter is set properly it does automaticly shut off at a safe SOC. The problem here is an incorrect setting in the...
