Separate names with a comma.
I had planned on getting the battery from Toyota, but they said they can't sell them over the counter any longer. They can only ship it to a...
You might consider the Lithium battery..... It cost less, and so far it's been working great for me. I certainly can run a lot longer in EV...
Post #5 You are trying to find out what the issue is. Swoping the wheels, you could eliminate them as the issue. If the problem goes away on the...
Swop the wheels with your other Prius. That's a place to start. And with the wheels off, check for anything bent, or broken frame.
It doesn't work.... I'm on my 5th change, no differenct. I guess it didn't hurt, but it's $5 for than the other oil. This will be my last time...
:confused::confused::eek::eek:o_Oo_O:barefoot::barefoot::whistle::whistle:(y)
??? Seriously? It's a very simple thing to do. Get all 4 wheels off the ground on jacks stands, then remove the wheels. It makes it a lot...
Yes, you can use a vacuum pump. And if you open the bleeder screw while you screw the pucks back in the fluid likely go out the bleeder screw......
Years ago Suzuki had a plat under the hood that said "replace engine at 50,000 miles". Seriously! That was in the 80's. 50,000 miles was a lot...
That likely doesn't happen. Oil blows by the rings, but the motor runs a lot faster than the hybrid turns it over to get it to start. Oil get...
You might as well replace them all. The other two "may" last a long time, but may die right after replacing the othe two..... Depends on...
Glad all is well. Check the coolant tank to make sure you have enough coolant. And you can use a smaller cable tie. The duct tape might fall...
You could wrap a cable tie through the open part of the connector and around the lower part of the sensor....
Their spec is wrong. Walfart wanted to torque the wheel lugs to 90ft#'s. I showed them in the Toyota manual it's 76. I wrote on the work order...
Make sure it is the correct way. You should not have to FORCE it.... Using plyers you could crack the connector. It usually is a tight fit just...
Why not just tell them NOT to overfill the crankcase? How many times has this happened? Why would you trust them since they don't know how to put...
You did plug that back in didn't you???
I'll watch the news for the next few days....... :whistle:
The spring in the pcv valve weakens over time and heat..... I'm glad it's a $10 part and easy to replace...
Using gasoline is extrememly dangerous. Hope you are using a plastic container..... A spark could prove to be a bummer...
