Separate names with a comma.
^This. Took out the stud too, they're sitting in a drawer in my toolbox. .
Edit: posted in wrong thread. [emoji4]
It's 80 mesh from Amazon: 304 Stainless Steel Woven Wire 80 Mesh 0.18mm Hole - About 11.8 X 39.4 inch Roll(30cm X100cm)- Filter Screen Sheet...
At only 20K on the once changed transaxle fluid, it should look pretty much like fresh fluid, like the one Georgina Rutkus posted above, on the...
I purchased a new water pump and thermostat/housing and was going to proactively replace them when I changed the coolant at 124K miles, along with...
Our 2011 doesn't have the vent valve either. I did not do anything special like remove a hose from the fitting till coolant started to come out...
A few of these posts would be a lot easier to read if the walls of text were broken up into paragraphs. [emoji6][emoji23] Posted via the...
Maybe this is why? Some kind of chemical reaction? If this is not the first draining of the transaxle, which is usually very dark red, then it...
I put a small o-ring under the head of the OCC dipstick. I also put this oil and gas resistant thread sealant on all the OCC fittings to make...
Any other effects of the volatile chemicals in the combustion chambers other than the copious amounts of white smoke? Like heavy...
Only problem with soaking the EGR cooler in Oxyclean is that the rear nuts that the studs screw into are most likely rusty now. The EGR cooler...
Great, detailed, write-up. [emoji106] Even with a wire, because of the way the cooler opening is offset slightly at an angle, due to the openings...
I replaced it, the old one was dirty but seemed functional. Easier to replace it with a new one, they're only a few dollars. Keep the old one as a...
Forgot to mention, another set of handy tools: An extendable magnetic pick-up tool, looks like an old school radio antenna with a magnet on the...
Hmm, no noticeable oil consumption in our 2011 Prius hatchback at 130k miles. But the oil is very dark at 5k OCI. Using Mobil 1 0w-20 full...
Wow, someone didn't use a torque wrench, or seriously over muscled those cowl nuts. Did you remove the lower mounting stud in the middle of the...
They use Sil-Glyde in the Nutz About Boltz video, so I picked up a large tube of that. The important thing is that you don't use a petroleum...
I've heard that Berryman's B12 piston soak is a good way to to free up piston rings that are stuck with carbon deposits. You did dump and replace...
That's not your hubcap rim, that is the rim. Is the wheel/tire holding air? That's your first clue whether any permanent damage is done. If the...
Fumoto valves are very convenient and easy to to use for less mess. However, the fact that the valve remains screwed up into the oil pan means...
