Separate names with a comma.
The brake control system has a very deep level of self testing and error reporting. It would not be a simple matter to attempt a repair without...
In the state of Massachusetts, they have a bill called the Right to Repair: The Facts | Massachusetts Right to Repair It has been a long trend,...
From your description, I would say no, that is not normal. You should hear the pump in the brake actuator run, which sounds like a small motor....
Best software / hardware to recover codes from 2004 Prius? | PriusChat Look at Britprius's post to see what is possible. Mini VCI for...
I use ethanol free gas, and it does give a slight boost in mpg in the Prius. You didn't say what it was that was fixed on your engine. Perhaps...
Yes, that's right, pairs of modules in 14 blocks. So that would make it at the end of the pack. Cancel my previous, heh. Get the "mini VCI" from...
It sounds like you did everything that is recommended. Module 14 is in the middle of the pack, where heat is the highest. It is also a good idea...
Time to replace transmission fluid, if that has not been done.
This is true when using few chargers, although most use several chargers at a time. And then there is a step which connects all modules together...
This "whack-a-mole" situation was mentioned on the Luscious Garage blog concerning battery failure. They opted not to pursue reconditioning and...
It might be a bit too soon to change the inverter fluid just yet. Has the inverter pump recall been performed? If so, then the fluid should have...
Yes, as in those little Mabuchi motors are DC permanent magnet types, and so will change direction with polarity. Perhaps the leads on the motor...
I think you mean .19 amp drain. Is that right? How much do you drive the car normally? Miles per week, how often, that sort of thing. Do you have...
Here is a gif of H12:
Could you give us more details on the exact part replaced, and the diagnosis that Paul made? Just for the record here. Maybe Paul himself can...
I would use 2 pins, and push them through the insulation of the power leads to the existing motor, left in circuit as is. Attach the DVM to the...
One of the possibilities for generating the isolation fault is for one or more of the HV battery modules to have a small amount of electrolyte...
The P0AA6 in the GenII is a show stopper (but not in the GenIII). As pointed out in the above link, this is due to an electrical insulation fault...
The shifter jumping out of position has been mentioned before. I seem to recall that it did have to do with plastic flaps inside becoming stiff,...
I do not know. As of early this morning, we had a few patches of snow lingering about here and there. UKIRT Camera
