Separate names with a comma.
As you can see I was able to unclip that entire housing so now I can get closer to the pins to test the other side. Should I select the 15v on the...
If you look at second picture of my post#46, there are more than 11 wires going into that pin set where the other side of the two wires that are...
Thanks, Maybe I will try to get some testing from the back pins first, just very tough to get to.
Yes thank you! That is exactly the way I was thinking. I could just pull or cut the wires from the other side of the pin and test that side. Would...
I’m a little lost when you say I should be able to get continuity from the head unit to the door, not sure how I would test that. If the actual...
Good suggestion, will the door speakers have their own separate line or will they be connected with the dash speakers going into the head unit?The...
Tried the 15 volt setting and no movement on the wires coming out of the clip-frustrated, thinking of running a separate speaker line to the back...
OK, I’m at a dead end. Meter is working and I got a reading on the meter from the speaker connections. I tested the wires coming out of the door...
You are correct sir, wow I feel foolish. OK back to checking this out...I’ll be back soon.
The meter does not move when I touch them together. There is a small ride dial on the side the says “ohms adjust”. I played with that and nothing....
You will have to have a little patience with me as I am not experienced with the meter. I attached a photo of how I tested it. I reversed both...
I still can’t figure out what’s going on with no signal. I connected the wires and have a solid connection in the kick panel and at the speaker. I...
I took off the door and found a COMPLETE HACK job. I have to take back what I said about the installation company, this all had to have been done...
Thank you, I capped the wires and hope to tackle this more tomorrow when I have time between work and the kids! Something I was thinking about,...
Thank you for the responses, I don’t have time today to take the door off. I can’t see why the termination at the speaker would be screwed up if...
One more question, I’m assuming the signal is coming from the BACK of the pin I have pictured, and then routed to the door?
Well I tried to reconnect them with solder on the end coming from the door and then switched each line of the speaker wire and still no sound on...
I have no problem with mistakes, it’s when people hide them. If they would have said I accidentally cut into your speaker wire, but fixed it no...
This is what happens when you trust a company to do good work. I get remote start installed and few weeks later find out my door speaker doesn’t...
Thank you Frodoz, where would you start if it was you? Pull the door and look at speaker connections first? I don’t believe following the wire...
