Separate names with a comma.
did some disassembly this morning.. only to find out that where I need to tap into the HV supply to install it the way I want... requires you to...
uhh... simply changing the display.. doesn't reset the maintenance data... and it'll come up every single time you start up the car still.. that's...
if you want to sacrifice any storage space for more battery packs.. it'd improve.. though you also will have to start factoring in the additional...
i'm still deciding, but i have the package 2.. so the stock antenna base is smaller than the 3&4.. and is the same as the Scion iQ.. and I believe...
the Prius override is for OEM headunits ONLY. aftermarket headunits have their own override methods.. most times pretty easy, and a lot more...
it's comfortable for me.
any decent tint installer with good film can tint over the dot matrix fine. here's a close up of mine: [IMG]
hey there! well, for the V.. the speaker is pretty down there below and behind the driver side headlight as with the other Prii... the only thing...
might have been better if you had posted in the correct forum section... can't say I have seen the issue you're describing..
wrong car..
I am helping to work on one.. biggest limitation is space for the battery packs.. you can only put in so much.. looks like it'll have to be a...
I should be getting my Beat-Sonic one in a few weeks. ^_^
fyi.. if you guys are still looking for how to reset the notification... look on page 349 of the owner's manual.
well.. if you guys are just looking at numbers. [IMG]
there are screws that you need to remove for the trunk panel pieces. the b-pillars, you need to again, work from the bottom.. and move your way up.
no.. those types of shark fin antennas just go over and cover the stock base.. no need to remove the stock base.. if you were to replace the...
gotta be careful using EV too excessively though..
i was like.. OnStar?? that's totally not a Toyota thing... lol.. it's mostly GM. but yeah.. here's the site for Toyota's Safety Connect: Toyota...
ehh... i suppose the better comment is... why not? though.. if it was me... i'd spend the money and focus on other modifications that are more...
i installed it as with any other Toyota application.. i can't remember the resistor value.. but it's listed in their instructions as far as what...
