Separate names with a comma.
Happens all the time and is well documented in PC. Has to do with the VSC (vehicle stability control) and other protection circuits that prevent...
I remember when I first paired my 7th generation iPod Nano. On the Audio screen there are two buttons at the bottom, RPT and RAND. I think the...
I have to drive through three of these "traps" every day on my commute. I can confirm that with cruise control set there is extra drag. If I...
Back pressure might have been an issue on the Gen II since there was a rubber seal in the filler tube and the fill pressure served to expand the...
Have you tried a different "pump" (it's not a pump, just a delivery control device) at the station, or a different station? With my somewhat...
Most any other car you "Start". The Prius you make "Ready".
I will agree that cold solder joints are difficult to detect. You have to get up close and personal. Would recommend a 2X/3X magnifying head...
Perhaps a bad connection at either the positive or negative terminal connection to the 12V battery. Swapping out the battery temporarily cleaned...
Oh, I don't know. It could be a weak 12V. I know when a Gen II does this it is a good item to check. The Gen III probably does the same thing....
Welcome to Prius Chat !
Usually the receiver/dryer is replaced when the compressor is replaced. It must be down there near the compressor somewhere. I can't see it. There...
Any cool-down times will vary depending on initial inside temperature and outside air temperature (and the ECO or Normal setting of all things),...
Well, I would say with only a couple of days ownership the dealer would still be responsible for making sure all systems are go. If it was not...
I would say you still have some more warranty work to get completed. Like until it works without any issues. Was this vehicle a Certifed...
Your article persuaded me to take a look at my intake air area just now. The Gen III is a bit different. Easier to get at the MAF but much more...
I don't think I ever saw any deposits on the MAF. But the hot wires you are cleaning are up in there and a little hard to see. The throttle plate...
I have a Presta chuck somewhere around here. Don't use it much. Just swap out the Schrader when I need it. The hose could be replaced. Every time...
