Separate names with a comma.
I would like to see photos of how PIS do their ICE kill wiring. I have got some heavy coil springs on order and I will be installing them myself....
Single cell chargingļ¼3.8V - No single cell should exceed 3.8v during charging. BMS setting. Battery pack chargingļ¼3.65V - Complete battery pack...
GBS cells are rated to 3.2v. Not 3.8v. See here Elite Power Solutions
I might try it on the weekend using a 33Mohm resistor across V+ and pin 2.
For FWD's Elcon charger mod I would go with using a 6Mohm trim pot if they exist. But I would not adjust it to any lower than 1 Mohm. So say a 5...
Using values from FWD's Elcon charger. R1 - 600000 ohms R2 - 8500 ohms Trim Range (Decreasing it only): Note I only tried this quickly...
Below are the calculations using the PDF for reducing the Elcon charger voltage endpoint. R1 - 482300 ohms R2 - 8680 ohms Trim Range...
I would go with using a 6Mohm trim pot if they exist. But I would not adjust it to any lower than 1 Mohm. So say a 5 Mohm trim pot in series with...
Do you think I am stupid enough to do this mod which has never been tried out to decrease the voltage endpoint. It has only been used and tested...
I calculated your Radd = 5.4 Mohms using the calculations given in this PDF...
Too hard to use Excel on my IPad. 504kohm is R1.
He does not show how he derived " a 10% decrease is a 10 x R1 ", he needs to prove it.
I think the control voltage of 5.1v should be 5.0v which gives me more accurate results.
R1 - 482300 ohms R2 - 8680 ohms Trim Range (Decreasing it only): Note I only tried this quickly on my unit, it seemed to work, but tread...
Post moved to http://priuschat.com/forums/prius-phev-plug-in-modifications/104914-elcon-charger-end-voltage-other-mods.html
