Separate names with a comma.
Hi FWD, What is your battery pack internal resistance according to your Canview when your A123 pack is connected? Mine is about 0.05 ohms to 0.09...
Did you see your charger go into constant voltage mode and see the charging current slowly reduced to about 1 amp and then stop charging. Did you...
You are correct it is the NiMH ECU which changes CCL and I have also noticed that the BMSplus also changes CCL. The Canview V4 shows the original...
I have found that driving in OOG mode and having 72 cells instead of 70 the Prius cuts back on regen by reducing CCL and applying the compression...
Due to the obvious danger of electrocution :rip: with working with 240Vdc I do not go out of my way to spoon feed others who have little knowledge...
Maybe you should take your own advice. Look at your own posts before you criticize others.
Hard to get isolation between 12v and 240v (traction battery high voltage) using an electronic component such as a power transistor. Isolation...
When a battery pack is put together at the factory they make sure all the cells come from the same production batch. Then they all have the same...
You are not Dan Lander - Dan21. There is a world of difference between you and Dan Lander. Dan Lander's opinion is highly regarded in the PHEV...
Only used the calculations supplied by the PDF. You can see how I scratched away some of the varnish on the PCB layer pad edge to expose the...
Maybe 200amp for greater starting torque through the inverter in EV mode? Does the 10kwh PIS kit offer a higher starting torque in EV mode before...
PIS sell a "ECM assembly" as listed in the price list for DIY. I have no idea what it looks like. I believe this is the part which allows EV at...
Hi Planetaire, Do you have a shortcut to a photo of the ECM assembly?
Hi Planetaire, It looks like all control to allow EV at high speed is done through the Canbus only. What do you think?
Wth! Wadh. :censored:
The HEV Engineer makes a good point of contactor welds. Best to use a contactor in both positive and negative legs. If you are really worried you...
Maybe PIS make the buyer sign a non-disclosure agreement before selling the kit. How else could they stop their secrets from becoming public...
I bit the bullet and did the modification. I put in a 10Mohm resistor which according to my calculations should give me an end-point voltage of...
Hi Texas, This topic is about DIY BMSplus PHEV kits for hobbysts and EV enthusiasts. You need to spend some time researching and studying this...
I have just made up a graph showing the different values of Radd over a range of end-point voltages for my Elcon Charger which has a existing...
