Separate names with a comma.
Whoa whoa whoa we're getting way off track here If you're going to use the seven button remote you will need the GPS nonsense that goes under the...
Wait a minute If I'm not mistaken this is similar to my Siena van I have two sitting here that I can take out but I haven't done it just because...
Generally just tightening it like you're supposed to You should be able to tell pretty easily whether it's cross-threaded or not by looking at the...
This is something you want to rethink immediately You're looking at cars that are now what 10 years old minimal or generation 3 stopped in 2016 or...
Seems quite a few have this problem I don't know whether it's a scanner issue or something else I mean at this point I would be pulling out my...
I believe there are some at the corner of the back of the roof square hole or rectangular hole is the case may be but I'm not positive I'd have to...
This has been hashed out here the last 15 or 17 years or so so plenty of reading 12 volt batteries are pretty subjective so it was always that and...
Any of the four button MFDs should work in your base You have no backup camera or anything like that so you're good even if you use an MFD that...
Yes it is possible I just don't really know what I'm looking at but I will hook up TIS this afternoon or evening and run the car a while and see...
Some of those lug nuts on specific vehicles were like dual ply especially some on the Chevrolet stuff in certain years and they do wear out rather...
This will take you maybe 45 minutes or so aside so for 90 minutes of your time you're saving a grand and labor yeah I'll take that every day of...
Nope we don't need anything. You'll want to take the hub loose from the strut undo the big nut hole in the axle to the hub allow the hub to pull...
Believe it or not I just blast them on and blast them off with my big DeWalt 60 volt half inch drive a gun I don't try to kill them this is the...
I have an '05 that's completely apart in the dash area so I can take that off pretty quickly have a good look at it and that car was working fine...
Man our gen3 had no issues making heat 21° weather 18 no problem didn't do anything nothing in front of the radiator none of it course we're not...
I don't know it's been really cold the last few days or so so I haven't been able to get down low enough to really look I think it is moving from...
In the help section in the auto parts store you should find a rubber cap with a little shaft sticking out the end of it that should fit in that...
