Separate names with a comma.
So are you talking about doing other testing and no longer doing the parasitic draw testing? If you are still talking about parasitic draw...
If you go back and read those posts again, you should see that they get the ammeter set up in the circuit and switched on, do all those things,...
Sounds like you need to up the quality of the videos you're watching. In the context of monitoring a circuit's current draw, that makes no sense...
No. What would that accomplish?
I'm not sure what the intermediary number(s) would be, but ultimately you would hope to see it down to the ~16-30 mA mark.
2004-2005 ODO topped out at 299,999. They fixed it in the 2006-2009.
As long as you need to which would be 20-30 min at a minimum until the car is fully quiesced. You might notice it is highish for the first 10...
No, it just matters that it is held firmly and not moved. You will need to use some kind of clamp or you'll get cramps in your fingers or you'll...
You need to clamp it securely and leave it in place. If you move the probe on and off the post you just break the circuit so no current is...
Yes, in that configuration you will read 0.00 (Volts) because there is no potential difference between the negative pole and body ground. Even if...
And the "10 spot" is as in the image below? [ATTACH]
I'm sorry but I can't make anything of your photos. It's too close (so no context) and too blurry so I can't make out what wire you're talking about.
It depends on how you're testing them. You assume we know what you did when you say you did a load test. Was the 7.49 V module one of the ones...
I hope you got Toyota SLLC. While aftermarket coolant may be okay to use, it is never a good idea to mix two different coolant formulations. It...
I'm not sure what you mean by a regular 12 V battery charger, but any automotive 12 V charger will do for now. If you have the choice to use a...
Does that include the fuses in the interior fuse block (LHS) and the fuse block on the positive terminal of the 12 V battery?
Have you checked the voltage on the fob battery? If it is 2.9 V or less replace the battery It takes a CR2032 lithium cell. Check the voltage on...
The system can isolate a line when loss of pressure is detected – because of a leak for example. So it would make sense you need to reset...
You can disconnect the inverter pump at the plug shown in the image below. This is a more convenient place than at the connection on the pump...
That is correct not all codes can be cleared by disconnecting the 12 V. That is why after completing repair work codes shouldbe proactively...
