Separate names with a comma.
Found more rodent damage while draining and filling the engine coolant. Something chewed off one side of the refrigerant line insulation near the...
I just rewatched Nutz About Boltz's video on cooling system drain/fill and realize airbox and intake system is intact and no need to squeeze and...
I'm assuming that the air bleed valve looks something like this one for an MR2? [ATTACH] .
This may be be a dumb question but this is a 2011 without a coolant bleed valve, correct? Also, when in inspection mode or maintenance mode...
Here's a picture of the EGR cooler I got off eBay to pre clean and swap. I couldn't see any light through the middle of it. [ATTACH] Posted via...
To the OP, PriusII&C, sorry to hijack the thread with all the extra discussion above. Here's some pics of my cooler and EGR valve removed at 125k...
I think I'm going to try to find these as well. My fingers and hands are still sore trying to get the hoses off the EGR cooler. At least the...
Yes, that would be my thoughts as well for the next time. I'll have PTSD on this one for a while though. I hope it's like women and child labor,...
Thanks, I used an extra long pair of needle nosed pliers with an angled tip. And the handle kept getting in the way of all the hoses and orange HV...
Lol, I was wondering about that as well. .
Nice find, but you'd have to buy 5 sets. .
@ChapmanF, are you sure that the head or business end of those fancy hose clamp pliers can get into and be properly positioned on some of the...
I think I'm with Mendel on this one. I don't want to spend more time than necessary lying on top of the engine, reaching down to get at those...
Walking in the snow, especially heavy snow, is no fun though. .
I also found it very difficult to remove. It seemed to almost be tightening when going counter clockwise. But clockwise was definitely tightening...
I have one of those ground wires. You can easily make one out of 10 gauge wire and some spade terminals. .
Also, does everyone remove that largish coolant hose that goes to the block next to that bottom bracket on the cooler for easier access to the...
I took out the bottom EGR cooler nut and stud as well. That's one battle I'd rather not have, EVER again. Took me almost an hour to get...
Yep, key word is "crude" tool lol. .
So today I'm taking another whack at the EGR cooler swap, and I still couldn't budge the d@mn radiator drain spigot. I tried reaching down behind...
