Separate names with a comma.
His exhaust might be steamy after that. :whistle:
The cars are more-or-less the same. When they come up with two tire size options, they try to keep the outside diameters roughly the same, though...
Any automotive 12 volt charger will charge either flooded or AGM style. It's just some chargers have a setting optimized for AGM, slightly higher...
Use the "report" button, let him (likely the one and only moderator, Tideland Prius) know it's sold. I think usually the title just gets ammended,...
Toyota should be reading this whole #$*7@ thread...
At least there is paint. Worst is clear coat on bare machined aluminum. It looks cool, 'til it starts to fail, then you've got a "clear" view of...
Here's the alternate rubber cradle I'm using with my floor jack, when needed: Floor Jack Saddle The only issue: it's got a great goober of weld...
I get the sense the 5th gen scissor jack bearing points are actually usable, as-is; the proscribed zone is beefed up some?
You can get replacement floor jack cradles with a flat rubber face. what I do for tire rotations is: 1. chock rear wheels and release parking...
How fast you're going also a factor. Anything over an inch, I'd slow to a crawl.
Lower mainland BC (Canada) Costco currently showing two all-season options in stock.
Maybe due to the emphatic warning from Toyota, too.
Sometimes the “improvements” can be legislated stuff that is mostly frustrating. Or cost-cutting measures tarted up with lipstick. Not always, but...
How long have you had it? Any history of head gasket failure? Exhaust Gas Recirculation system and intake manifold ever cleaned?
Hang onto the “old” parts.
Finding paint code for rims is always tough; not sure why, considering curb rash is a fact of life.
Just calculated but likely close: 10’ of 2x4 at 1.67 lb per, say 17 lb. The deducted chamfers likely equivalent to the thd rod nuts and washers,...
Low rise ramps you can even just cobble something out of 2x lumber. I fashioned some up and over ones, using 2x4’s on edge, but in hindsight...
Usually misfire codes, P0300, P0301 or P0302 (general, cylinder 1 and cylinder 2).
If you’re considering an engine swap, I’d stick with a Gen 3 donor. 4th Gen engines have resulted in nagging overheat issues, and AFAIK no one’s...
