Separate names with a comma.
It is possible to get a P0A80 DTC without a battery block is weak code accompanying it. You need to check the block voltages to see if a cell...
It seems that the brake light switch is not closing properly. Pull up on the brake pedal and see if that turns the brake lights off. The pedal...
You should have measured the distance between the outside of the plastic end caps between the 28 modules before you loosened them. If you have...
You will need to order a new connector from the parts department at a Toyota stealership. It does not appear that your connector can be repaired
You will know how well you've done in the next few weeks. Fingers and toes crossed for all the work you put in and the $$$$$ you spent. Get an...
What I meant was for the skilled individual working on it. I don't have a crowd around me when doing these repairs/rebuilds. In fact, I yell at...
Perhaps you have forgotten what amnyce wrote, dolj. He was the first one to use the word silly. These are his exact words: How would it be more...
Better get the input of a few other people before you proceed. It isn't normal and its cause is lurking somewhere inside that battery.
That is odd. I haven't seen that on the batteries I've worked on. Always reads 0V there with the plug removed. Wish I could offer some guidance...
There's no danger of installing the service plug with the battery case open. Here's a photo of a helpful hobbit checking the voltage on his...
You will not read battery voltage until you re-install the service plug - that orange handle thingy that you removed before you started to remove...
Still odd that you had two weak blocks even though one was definitely bad because of one module with a dead cell in it. I guess you'll find out...
No dolj, a new battery isn't just its modules. The battery control unit is reused by Toyota and everyone else for that matter which effectively...
Noted. So am I. We're men. Ape men.
Just so we're on the same page. Block 3 contains modules 5 and 6 not 21 and 22. The block count starts at the blower end. It's possible that...
Noted. I forgot that Toyota starts the block numbers at 3011 instead of 3001 like most would do. Also note that these were on-the-fly comments...
Well, you should read what I posted today. You should drain the modules to a lower voltage to find the weak ones, if they exist. The BCU does not...
Not likely, two battery blocks were weak that means at least one module in each block is weak.
No that's probably good then. Not having to buy replacements is a great place to be. I just went back to read your DTCs. The last four modules...
Complete instructions are provided in my earlier post from yesterday. Good luck.
