Separate names with a comma.
OP, get these and replace your oem foglights with them, they are pretty much driving lights. I've got a pair on my Camry and they're great:...
Or, turn the fogs on and off when facing a wall at about 20 to 30 feet. Glare (light) from the foglights present above the lowbeam cutoffs when...
The DRLs are on during daytime operation (headlights off) only if set up to be on. To further complicate matters, not all Gen 3 Prii were...
Similar experience here. They try to sell throttle body cleaning, injector cleaning, etc., but for some reason, they don't want to do the...
Yes, you are correct. 50/50 mixture, sold premixed.
Sigh, the things we give up to get an industry-leading fuel efficient vehicle. ;) :D FWIW, most of the things you stated as wants, can be added...
Probably a combination of factors. Poor design, which routes the coolant carrying hoses close to possible ignition/heat sources. I know I've had...
Another thing to keep in mind, is that Toyota uses 100% glycol based coolant, there is no water (50/50) to evaporate, therefore, the ignition...
Good point, I'm not sure if the vehicle that caught fire in the middle of the night had been driven previously to have hot surfaces (exhaust...
No, the pictures show the Right fender area, opposite from the inverter assembly is involved. In the OP's pictures, the right side is heavily...
You'll have a constant warning light on the dash, but as long as you install valve stems, then yes, you can drive around with no TPMS sensors.
?
1/8 inch over the top mark is OK. I wouldn't recommend hosing the engine and orange high voltage hybrid electrical wiring down with water. ;)...
If the fire started in the right front fender area, there's another thread here. Hopefully, data and the errors can be pulled from the vehicle....
As mentioned earlier in the thread, I don't think there'll be any useful data in the data recorder since you drove home after the occurrence. The...
OP stated it's reflective tape, not EL. The EL tape mentioned was for a motorcycle.
Looks pretty cool, but a little redundant on the lower doors/rocker panel area IMHO.
Hehe, sorry, I'm on tapatalk and don't see location info. :p
Buy some black PlastiDip spray, mask it off and go for it. ;)
You can get and install an engine block heater if you have access to a nearby AC outlet. The preheated block and coolant will allow heat sooner...
