Separate names with a comma.
Make sure you get the 3M exterior mounting tape, the dark gray/black double sided foam with the red backing film. Don't get the regular strength...
H11 b bulbs? With the ground return wires in between the mounting tabs, that position the ground wire at 6 o'clock position when installed? No...
The Morimoto HID kits are known to be high quality. If you had installed the original set using the HID relay harness, you may never have had any...
There's a thread: Murano/Corolla LED headlight retrofit | PriusChat
This post pretty much covers it: What did you do to ur Gen III Prius today???? | Page 469 | PriusChat The terminal referenced is one of the two...
I can't believe this thread is 18 pages long... :o
You might have to remove it, flip it around 180 degrees, the reinsert it. If you look inside the plastic connector shell, you'll see a small tab...
Make sure you get and use the HD dual relay HID harness too.
Yes, definitely an H11a bulb. An H11b bulb has the ground wire on the opposite side, between the other two tabs.
If the ground wire is located next to the largest tab on the base, that is an H11a bulb, and the ground wire is causing the ground shadow. The...
Nope, they go onto the wires first. See my previous post.
They go over the connectors on the end of the wires, then make a seal between the wire and the connector shell when you insert the connectors into...
If it comes with a harness, use it to avoid any problems.
The 17 inch wheels will give you a firmer, more controlled ride, but at the expense of a few mpgs.
No, it will work for any combination of incandescent and LEDs.
Lots on eBay http://pages.ebay.com/link/?nav=item.view&id=331611258963&alt=web
Mainly for a small effect on airflow over the wheels/wheelwells. The effect is negligible. Take the covers off and get some center caps to cover...
Wow, great job on fabbing it up to fit. So, the height adjustment is done using the oem bolt/screw on the back of the headlight housing?
I think the cutoff shield gets bent slightly from bending the metal shield up then down to access the squirrel finder cutouts. That's the main...
Those center caps and trim rings look good. :)
