Separate names with a comma.
Pulling fuses while car On =bad. :( However, I doubt that any permanent damage was done. See my post above and cycle the car On/Off however...
Many times, a Check Hybrid System error condition will eventually clear after the initial condition that caused it is rectified. It might take...
H9 bulb mod (link in my signature below) gives about 150% more light than stock. 35w HID kit gives about 2 to 3x more light (depending on bulb...
The rims won't fit, they are a different bolt circle pattern. 5 x 100 for the hatchback, 4 x 100 for the c. The tires, probably not either. Unsure.
There's a whole range of colors available on ebay (red, silver, gold, blue). ;)
Just connect your power wire to one of the two open terminals at the rear of the fuse box, where the two red wires are in the pic below. It's much...
Tip, it's always a good idea to remove the fill plug first, before removing and draining the fluid out. That way, if for some reason, you can't...
Depends, might need a larger floor jack, jack stands, ramps, etc.
The linked article mounted the LEDs in old reflector type headlights, the Prius uses a projector. The LEDs don't have the point source light...
Not all trim levels have the Auto switch position on the light stalk. The difference in mpg with DRLs on vs off is pretty negligible, similar to...
Those caliper covers look sharp. :D
Let's see the drums. :D Here's a pic I had handy of my calipers (sorry it's blurry) :D [IMG]
The brake sensor switch could be failing as well, not just requiring adjustment.
Do you mean an LED you had in the parking light position? The squirrel finder cutout is a small hole in the oem projector's cutoff shield that...
Whoops, OK then, carry on. :)
Whoever edited the thread title should take out the word "damaged". I don't think the OP is trying to buy a damaged headlight. ;)
eBay usually has a few available. Watch out for broken mounting tabs though.
I tap my seat heater fuses for all of my power needs because our level 3 Prius doesn't have seat heaters. ;)
Here's another eBay source for the hubcentric rings, at half the price of the link above:...
Soldering would be better than using crimp connectors. Twist exposed conductors/wires together, solder, heatshrink insulation around repair.
