Separate names with a comma.
Here is a pic of the fuse box in the engine compartment with the cover removed: [IMG] You can use one of three sources to connect your red...
You can try swapping the bulbs from passenger side to driver side. If the previously good bulb acts like the bad bulb, then it's the ballast. If...
Our Costco wouldn't even install a tire size that was an option on a higher trim level for our model when I installed 17 inch rims on our vehicle...
You only need one screw on each side to secure the foglight into the shrouds. The screw goes in the side opposite the two that slide into the...
It's more likely an EMP could disable the ECU in your car than for someone to hack into and take control of it. And even then, that would be...
That hardly looks safe to drive. There's little room for the driver to sit without bumping into the sup.
If you don't feel comfortable installing the HID harness, I'm sure a stereo shop could do it in less than 30 minutes. Why don't you just turn on...
Yep, that modem rental fee or purchase your own cable modem was the last straw for me. :mad: Switched over to TV and internet service from our...
Not sure, but are you willing to gamble on purchasing another brand which may or may not have the same problem? Buy the HID harness, it's less...
It is what it is... whining about it isn't going to change the fact that using your OEM lowbeam circuit to power the ballasts is giving you a less...
Darn, the one day I work all day renovating my parent's kitchen, I miss out on this sweet all leather steering wheel. :cry: I don't care for the...
Agree, not feeling the tail light paint job. Also, I think he means "brushed" aluminum on the caliper holders, not burled aluminum. ;)
Looks great, gives the Prius a much more aggressive look. :)
Because, as I explained earlier, HIDs actually use more power at startup than conventional lighting systems. HIDs operate by sending an arc across...
Everything you need comes in the kit. In fact, it comes with extra screws. so when you have extra screws at the end of your installation, don't...
What do you want to hear? Two people already told you your problem is likely due to your HIDs not getting the power they require to initialize...
Because like fluorescent lights, HIDs require a high current draw upon start up. That's what the ballasts are for, to supply the high current for...
Not plug and play. The delay relay specs states that the relay has a capacity of something like 15 amps, but the wires coming off the delay...
Whoops, I don't have a link in my DRL thread. Here you go: http://pages.ebay.com/link/?nav=item.view&id=321016256696 SCH-I535
I think you should reconsider leaving your headlight switch in the "on" position. There is a lot of electrical switching and demands for...