Separate names with a comma.
same here. 3-4 mpg bump
you can try taking off the fender liner to get to the bolts. No need to jack up the car, just turn the wheel out.
That's pretty low miles to be replacing brake pads unless previous owner was racing the prius. Most ppl can go close to 150k before replacing...
Might as well do coolant flush while you are at it since you are already draining the coolant, if you haven't done so.
i've had Llumar Metallic tint on the prius and Ceramic version on my Infiniti. Both blocked a lot of heat. Ceramic does a better job but more...
Sorry to dig up old post but I took my 2010 apart do clean out TB and EGR cooler. I did get a spare EGR cooler from ebay and cleaned it out...
I had the same code and was able to get home after restarting the car. Replaced the pump and the code went away permanently. The pump impeller...
which one? They have one for headlight and one for fog
Defective display. Dealer just replaced the radio when mine had the same issue.
Didn't even know tein made a kit for the prius. I had the same setup on my current 2010. I take them Fwy exchange at almost full speed. I get...
Plugs don't look too bad do you have plan for the rear sway bar too? Big improvement with both tower brace and rear sway bar
I would pick up the sway bar bushing and maybe the both stabilizer bar end links. When i did mine, the bushings and the end links were worn.
I saw this on another thread and been great for almost 4 yrs now. I dont like to mount things on my windshield so I mounted to the right of gear...
@tankyuong Pump was $245 from Toyota dealer. That's cheap!. I think all the pumps are made by Toyota but when sold by aftermarket, the name are...
No clamps, just held on by just friction. Just make sure that the new one is connected the same.
BTW, you can replace the pump from up top alone but way easier if you remove the plastic shield in the passenger side wheel well.
Just FYI, I just replaced my water pump this morning too after having to limp home and end up w/ P261B and P261C code. Amazon has the cheapest...
It's the check valve, part no 85321-28020. It's under the hood liner. My original symptom was weak passenger side spray. Cleaned the nozzle...
I bought a set of beamtech brand from Amazon about a year ago. I switched from HID after a couple of years of use. The cutoff line on the LED...
No need for resistor. Its plug and play.
