Separate names with a comma.
I was surprised to read that I must buy a new set of manifold gauges. I used my new gauges one time on my Corolla. Suppose I flush the red, yellow...
I am in the same situation. I plan to do the work myself. Most ebay compressors offer a 30-day return policy. If I pay $1000 for a new one or $100...
I watched many youtube videos. The instructions vary all over the place. 4 Seasons video was very technical. It is troubling that R-134a molecules...
I cannot find my thread. Did I do something wrong?
Thank you, Chap. This is what this grease is made for. I will use it on several connectors.
Bingo! I want to clean my engine without worrying about ruining the connector. see attached[ATTACH]
My pins have not corroded yet. I have been trying to think of a preventive measure to save the connector. I wonder if filling the compressor side...
I bought a can of Honda POE oil. I think that it will be fine. I watched a youtube showing a Ford system being fixed. The factory manual said to...
I just ordered a can of Honda POE compressor oil. Got my fingers crossed. It is in a metal can to keep out moisture. I read that a plastic...
Interesting! Shielded wires. The braid is attached to the metal sleeve. I can see that a center conductor short anywhere to the shield will cause...
I cleaned the horizontal glass and now my speedometer is clear. However, the cartoon that shows battery vs engine vs wheels is still hazy. With a...
My 2010 has the same problem. It is not the A C condensation because my A C does not work. I saw a youtube of a guy removing the instrument...
I used a flashlight and a mirror to learn more. I viewed it from an angle. The fuzz is on the actual display. It is not worth fixing.
I tried cleaning it with Windex, but it would not clear up. Maybe it is something on the inside of the glass. If on the outside, is there a...
The fuse was not installed. In the image, the metal shell (strain relief) is removed. The ohmmeter reads (almost) zero ohms. I was measuring the...
I did wrap the sleeves with electrical tape. The electrical tape repair did not last, so I removed the metal shell for now. I ended up breaking...
The cable is defective. Poor design or poor quality control. It should have been hi-pot tested at the factory.[ATTACH] [ATTACH] [ATTACH] Replacing...
I did not know that the electronics (other than the motor) were in the compressor. Interesting. I did unplug the power cable from the compressor....
And the fuses cost $35 each.
Yes, I also did the math. That is a lot of power. Fuses are over-sized to eliminate nuisance fuse-blowing. They are mainly there to protect wiring...
