Separate names with a comma.
Nope though my symptoms were identical to yours -- based on your descriptions -- my problem turned out to be nothing more than a loose middle heat...
I used slightly heavier gauge aluminum scrap metal cut to 2" length. Drilled a hole in the center and bent all sharp corners so they would not cut...
That gives me an idea of what the dealer should be charging once they confirm their official hourly rate. I will buy all the parts first so I am...
Finally they agreed to take my $20.00 . In the end it worked great with my standard printer. No reason to go page by page with a pdf creator....
I am having a very slow time registering to pay the $20.00?? Hopefully it will not be this slow when I try to research my repair procedure. I am...
I will give it a go. (I also have a 175 mega byte pdf bought on e-bay but I can't unzip it?)
Do you recall if there were any tricks to using the Firefox PDFCreator method described above or did it go easily for you first time?
Checking the valve like that makes a lot of sense to me.
Seems to be a fair bit of corrosion in the stator. How was the stem working? Did it move easily?
My Oldsmobile 1984 was simple and easy to repair but it rusted completely away. All the wires and connectors were corroding in its 12th year. It...
I must have been very lucky. For me the two screws only took a perfect fit Phillips head to get them loose. Then it was nothing to unscrew the...
Thanks for the reminder i will try tomorrow when i go for groceries. However, I am reading a post by gearhead600 about his damper issues and it...
No I think motor stays but the inverter must come out so electrical system involved, and transmission must come out too. No choice i guess
I guess I was lucky the two screws came of easily and I was able to confirm that the stem was sticking in place. Did not take much to get it...
I hope the plugs turn out to fix the issue. I am leaning towards a very different solution to my rattle under light acceleration. Seems my...
Great article your posts are all clear, detailed and well written. In short hand I will say thank you x 50. I think I have your damper condition...
I look forward to hearing how this goes. It looks like a pretty big job. If my rumble gets worse I may have to do the same one day.
That right there is an update to the ECU involved. If I install the new EGR valve with the new part number I will certainly have the dealer do...
Glad you were able to clear the CEL code. Regarding the shakes did you check the state of the damper between the engine and the transaxle...
I agree with Mendel. You are mostly trying to remove carbon deposit if you find the valve sticking. I was putting white lithium grease through the...
