Separate names with a comma.
Then just lay out a piece of the Soundskins Pro and tape the clear plastic to the sound treatment again using the blue painters tape. The Blue...
So now that I had all the Kilmat applied to the 4 outer door skins, I turned my attention to sound treating the 4 inner door panels. I chose to...
So after running the speaker wires to the 4 doors ,next was finding the best accessible place for the front passive Crossovers. I mounted the rear...
Yes the plastic might stop the water infiltration but it does very little to stop the road noise
Yes Soundskins Pro and Kilmat were both applied to both rear quarters as well as the battery tray area . And yes that is a pre fab sub enclosure...
The rear doors were much more of a pain in the A%#. I started by decoupling the inner plug from the outer plug. This is accomplished by removing...
This next part was likely the most tedious and nerve wracking part of the build. Running the thick 14ga KnuKoncepts KORD Ultraflex OFC speaker...
Next foam speaker baffles were applied to the outer door skin directly on to the Kilmat behind each speaker location. I purchased two sets of 6.5"...
Next step was removing the stock JBL 6"x9" front and 6" rear speakers. A 1/8" drill bit is all that is needed to take out the stock speakers as...
[ATTACH] [ATTACH] [ATTACH] Next step was sound treating the 4 doors. Kilmat was applied to all the outer door skins after removing the door cards....
[ATTACH]As you can see, even with 6 rolls of Soundskin Pro I still ran short to cover under the subwoofer so I used the balance of the Kilmat...
[ATTACH]Spare tire well with Soundskins Pro applied and Acoustic foam under the traction battery
[ATTACH]Soundskin Pro applied over the entire floor including the transmission hump. I ran the soundproofing as far up the firewall as I could get...
[ATTACH]Front seat area . notice the factory soundproof carpet under-padding and the white foam. These were re-installed after sound proofing the...
[ATTACH]tire well
[ATTACH]12 volt battery area stripped
[ATTACH]left side of trunk area where the subwoofer will be installed
[ATTACH]rear seat area stripped
Since you asked about the rest of the soundproofing ... here are some pics[ATTACH]floor stripped
I'm very happy with the results of the soundproofing and the materials that I chose to use. Especially the cost savings. (See my prior post from...
