Separate names with a comma.
Thanks for the info. So I'm guessing either a Mode 6 compatible scanner or tech stream at the things that would work here, other than just...
I did ask their tech support and the guy said it can't but their website says some of their newer ones can.
Agreed and I'm certainly not an expert here. It's not personal...it's just a fact. My Innova 3100RS doesn't have Mode 6 capability according to...
I will check on the Innova page.
I think you mentioned this but in the test for insufficient EGR Flow, the computer is using MAP Sensor data which means a bad sensor can trigger...
I think it's Innova 3320RS or something. But, it is still the same P0 code. Given that it didn't change from P0401 by replacing the EGR Valve, is...
Tried three photos but not sure I did that correctly.
More on the P0401... I replaced the EGR (valve section only) with a new off brand one (other EGR sections and manifold ports have been recently...
A little late for this answer but if you go beyond soaking up any oil at the bottom of the intake manifold, you might as well remove the manifold...
My scanner has live data but not tech stream so I'm doubting that EGR data would be found without tech stream?
Thanks for the repair manual info. I am leaning toward EGR valve as well, in part because of ski jump degradation. I poked around a bit after...
I did see some serious cylinder wear while replacing the head gasket so I'm probably just going with a JDM motor if this one fails again. is there...
So I'm not hearing or feeling any ICE problems. As long as the only code is P0401, is it likely to cause damage? Would a P0300, 01, etc. come...
Coolant level is steady. Ski Jump was somewhat worn so could be an issue. EGR and manifold thoroughly cleaned in last two weeks with completion of...
Gen 3 2013. EGR cooler was cleaned along with manifold. Miles are 225K. My thinking is that misfire codes would eventually be added if there was a...
I correct on assuming that a bad DPFE sensor or circuit problem is the likely cause of P0401 code when no misfire can be heard and there are no...
I have a 2007 and 2013
Interesting. Yeah, I've been seeing the JDM motors with around 40K for 2000 or so. reman if good quality would probably be superior. Would...
I'd probably do a JDM or junkyard motor (maybe $2K or $350 respectively) if the head gasket replacement doesn't do the trick. I basically will...
I think you're right that the head gasket might have been compromised by the earlier EGR problem. I think I remember doing a leak down test when...
