Separate names with a comma.
Yes, I would probably splice into the wire behind the connector if you can get to it. Solder and cover with heatshrink if you can.
I'm not sure offhand which speed the Prius CAN buss runs at, but I just looked at your attached file and it doesn't matter if the choices you list...
Ubiquitous=common. CAN is used in A LOT of cars, it's sort of an industry standard. I'm sorry I don't have time to dig into your wiring diagram...
CAN is Controller Area Network. It is probably the most ubiquitous protocol for automotive data busses. Depending on how much power you need on...
No worries. Believe me, the biz I'm in tends to make one overly defensive, and I can get riled up with the best of them so no harm, no foul. I...
Fossil fuels. But 35% of my electricity (and growing) comes from renewables. 0% of fossil fuels do, and that figure will never change. This is a...
It was a serious question, not a swipe. Full disclosure: I work for A123 Systems, in the warranty group. My Hymotion pack was "free" to...
Are you sure you can run both LP and gas in the same engine? Most mods I've seen for LP involve changing the injectors. My understanding was that...
There is simply no reason to use a Li ion battery in an application where the standard LA battery performs perfectly well and will last 5-8 years....
No individual cell group Voltages? I don't understand the SOC% curve.
Good experience in the marine environment for environmental concerns. Most people, even some really good engineers, get bit hard by missing the...
Nickel plated Cu is probably most common. Cu is a great conductor and relatively affordable, but when naked its corrosion potential is...
I don't think you're that far behind....I've read about smart grid stuff in Australia and wished we were making similar progress here. Charging...
I don't know for sure, but I would expect your cells to come with no buss bars attached at all. Shipping lots of cells outside a pack while...
You're right that the cells will balance themselves at whatever Voltage they average to (more or less), but DO NOT skip charging and balancing at...
I hope they give you more instructions that just the four pictures. Looks like you're right...all cells put in parallel and charged at once as...
That may or may not be your problem. A 1N4002 diode would be appropriate. Be sure you observe the stated current limits of the CellLog alarm...
How much current does the relay driven by the Cell Log draw? Did you put a diode across the coil to shunt off back-EMF when switching the relay off?
