Separate names with a comma.
I believe it has center bore of 56.1mm? and Prius center bore is 54.1.. You may need hubcentric rings to minimize vibration... Posted via the...
Perhaps something like this could put in place of factory foam pieces to avoid leak? Universal Seal 1 in. x 1 in. x 12 ft. Impregnated Expanding...
The grommets in bottom of 12V battery area are supposed to let water dripping out... I've found water in that area and it has been staying dry...
If you're not physically well to perform the task, then perhaps the shop you trust would be the next best choice.. Make sure that you and the...
You're welcome Sam, If you haven't bleed the air out of the system, then you should review the attached videos. It's a pretty easy task, and...
Have you scanned OBDII for codes? .
I recently done one on a fix upper I bought... I ordered Valpro head gasket set, head bolts and followed this video.. Watch "Toyota Prius 2ZR...
It only take one to purchase... Currently with social distancing in effect and if you're confident in the condition of your Prius.. I would say...
I have a tire recently replaced due to nail too close to side wall, and luckily I have road hazardous warranty on all tires I purchased.. And...
It's you vehicle, your property and you have the right delete your ad and price it higher if you wish.. Personally, I'm the type of person would...
Water does leaking into battery compartment in Gen 3 Prius, I found water in my 2010 fix upper I recently purchased and drained the water by clean...
Hi Sam, thought I would ask if you have bleed air out of coolant system after replaced control valve? Due to design, air can be trapped inside...
I'll try that when I have to replace them, this afternoon I swapped out a set of tires with my brother's Prius and most of the noise went away.....
Replaced rear bearing on my son's Prius little while ago, it was cake using long bolts and nuts through existing hole to pop them loose.. However,...
Looks like I may have to replace both front wheel bearings in white prius, bought it with blown head gasket and did notice noise while driving it...
I probably won't go that far to using a GoPro, but I do appreciate all the comments and ideas! So far all 3 of my Prius have been monitored...
Both super and lower radiator hoses are hot... .
I was able to get radiator fan to kick on by turning on AC... We found engine temperature is between 185°~202° while taking Prius on a 40 mile...
Glad I saw this thread, was going to get a set at a good deal but changed my mind when realized the center bore is 56.1 instead of 54..1. I don't...
Both engine oil and coolant were drained before head gasket replacement, my question was if I should and how soon should I drain or flush engine...
