Separate names with a comma.
The button is located behind the yellow sticker. There is also a five pin inlet for what is probably a field programming port. There is also a red...
Deleted
I was not asked for a max voltage. Where is this sticker you peal off to press a button?
It looks like my Elcon charger is setup for a BMS with a HVC of 3.8v. My mniBMS has a HVC of 3.6v. It looks like it may be a simple matter of...
Like Flan said. If the BMS fails to do the HVC event the charger will overcharge the whole battery pack and you would probably need to replace all...
It goes to 0.1 amps. My EV display meter will not measure any lower as it can only measure to one decimal point.
Thanks Mr Plug-in, I will install 2 more cells. See if it will go into CV mode. I have done my current control modification and it works. There...
That's a good point. I remember Mr Plug-in saying he could never get CV mode either using his Elcon charger, even after balancing the whole pack...
That would explain why my charger will not go onto CV mode. A 232v battery will never reach 240v to go into CV mode. The HVC event will always...
Deleted - blank
I just got a reply from Michael. I do have current control. Hello John, ▼ ENABLE CONTROL method 3: USING 2-5V CONTROL a. Control of charging...
What I am worried about is that if my charger is a Chinese clone and not a genuine Elcon charger. So there is a possibility that it may damage the...
Maybe this weekend. I have got no responce from my Email to Michael Cheung from EVassemble. It is also the after sales service of EVassemble.com...
Below is a picture of the crimping tool I used. Also a photo of a 16mm2 crimped lug before and after crimping. There are better crimpers around,...
A crimping tool is not cheap. You may be able to borrow one from a EV club or hire one.
A bit vague. Which cells are they selling? Maybe Headway. What exactly is included. Will be interested to see a price for ECM module. Do they have...
If you are planning on doing a lot of OutOfGas driving (which I do almost on a daily basis) I would go for the 175amp Anderson plugs. You can be...
Hard to say. My cells get a bit of top balancing at the end of every charge so I have not needed to top balance yet. I have only been using the...
To disable the miniBMS HVC would be stupid as it protects the battery pack from overcharge. In my case I can reset charging after HVC by turning...
