Separate names with a comma.
ok, here are the results weak cell test 10 mins at 2.28amp discharge voltage at charge ..........voltage at 10 mins load connected.............
Ok, just got home and will be messing with the pack here in a minute or two
Ok so parallel charge those four to 8.0v then discharge each one of those for ten minutes with the bulb and post the results? Just want to make...
Well, the mail just came and went. and no modules. what a let down, usps is getting bad. i sent something to boston and its there in 3 days. usps...
What do you think? do I have any bad modules or doe it look ok. if so should I put the pack in parallel and discharge it down to 6.0v with a...
i edited my results hopefully thats better
ok i did the taillight test 60 second intervals the little light was pulling 2.28amps according to my meter. here are the results At rest...
Ok. i disconnected the wire i had on both sides so i could take the pack out of parallel. all voltages last night at 11:30pm were 7.82v (they were...
I most certainly don't want to do this again if I can help it. All I want to do is get this to last me to spring (be great if it went much longer)...
Yes, I have them charging in paralell. They were at 7.46v and after 2hrs they went up to 7.92v. Could I be doing something wrong.
Ok I left for work but before I did I shut off.the charger. I had it charging at 3.5 amps For a hour and a half. It was up to 7.94v. Is that good...
the pack is hooked up in parallel, the whole pack. so far its evening out at 7.46v and ill let it sit for and hour or maybe overnight and get up...
also what amperage is should I be charging and discharging this battery pack at. I am going to try and charge the whole battery pack at once in...
Yes, my superbrain 977 will detect peak voltage but is that's safe to allow a Prius battery pack to go to peak voltage?
I have one of those ebay turn signal resistors. Wil that work? Your talking about using the resistor if I want to balance the whole pack at once...
Yes i labeled every module. 1 to 38 starting from the ecu side of the battery. could i disassemble the pack and turn all the modules so they are...
how would i top them off. meaning what voltage should i run them up to? 7.8? 8.3? and at what amperage. i would be using my super brain 977...
replacing an mg2 is dooable at home. your dont have to completely drop the trans out. just get the trans down far enough(yes its still hooked to...
hmmm. the mg2 temp is not higher than the mg1 so thats a good sign. also you might wanna check with california state law on the warranty. correct...
So will the prius automatically balance the battery once I get it back together.
