Separate names with a comma.
My hood would occasionally not pop up after I pulled the release cable until the latch parts wore a bit. I would have to pull it up or smack the...
Mendel, You left out your third and entirely legitimate reason: 3. It is cheap and I either don't have the money to spend or would rather spend it...
Here you go: Oil Change Door - Permanent Solution | PriusChat
Next time you may want to consider this if it is in your budget: 1740 POWER FILL PRO 1.5 gallon I find it very useful now that I have two cars...
Yes. The bottom picture in Post #25 of this thread is the "before" picture.
Thanks to Prius-Alpha alerting us about corrosion of the compressor control circuit wire connector, I was prompted to neutralize the corrosion...
Ask for your old compressor to be returned to you. If you can, drill out the rivets and take off the connector. If you can't do it, maybe another...
Attached is a sanitized copy of the Warranty Enhancement Notification - ZE3 letter I received.
I searched the GIII forum and did not find anything about this. Today I received a letter* from Toyota, subject: "Warranty Enhancement...
The picture of your connector with the green corrosion inside the connector is quite different from the corrosion on the outside of my connector....
^Non of the above, rather after further inspection, I am fairly certain it is galvanic or dissimilar metal corrosion. The body of the compressor...
I inspected the AC compressor electrical connections on my 2010 Prius with 68,xxx miles. There are two electrical connections to the compressor,...
Good thought about dielectric grease. Has anyone asked the dealer if cleaning and applying dielectric grease or other corrosion inhibitor to the...
Just to clarify, after the aluminum hinge is installed, the original plastic hinge crease hinders the operation of the aluminum hinge. If you...
Unfortunately, Maryland also ended the exemption from Vehicle Emissions Inspections for the Prius and similar vehicles last year. I had to my get...
You do need to cut the plastic hinge groove in the oil change door if it is still intact to allow the new aluminum hinge to operate freely.
This topic has been inactive for some time, but since it has come up again I thought I would comment on Rude person's's commercialization of my original...
If the above suggestions do not work, try disconnecting the negative battery cable for one minute and then reconnect it. You will however have to...
You could have some corrosion between the hub-rotor-wheel. Clean all those mating surfaces and you may be OK.
Check the rotor with a dial type run-out gauge. It could be warped.
